Need help from the metal workers....

Ken (48 Cub)

501 Club
I am trying to drill a 3/8" hole in the seat bracket on my CC1282. I got a new seat and the holes don't line up of course. The bracket is like a leaf spring, very springy. No drill bits that I have will do it, not even titanium. What do I need to buy to drill these holes?
 
Ken. If you can't borrow a solid carbide drill (which are very expensive), then try a carbide tipped masonary drill. Be prepared for it to possibly chip, though, but should work ......... :)
 
Ken,

1. Start with a small drill first.
2. Use as much pressure on the bit as you can manage so the bit keeps cutting instead of skidding.
3. Use a slow speed.
4. Use plenty of cutting oil.
 
Ken,

You might try Drill bits made of Cobalt. They aren't as brittle as carbide. And I think that they are less expensive.


Also, use George's procedure. That should get the job done!

Good Luck,
Brian
 
ken, considering you are talking a one time project, instead od spending $$ on high priced bits, take it to your local machine or welding ship. They will already ahve the bits on hand, and will probably only chage 5 or 10 to do it.
 
You could use a Dremmel tool or die grinder with a small stone and grind a hole through it. Nasty and time consuming but cheaper than a carbide bit.
 
Back
Top