Well Ricky.
What we are told and what the truth is, are sometimes far apart.
It is a nice bike and I did ok on my trade. I started into it today and decided I need a manual and some good quality time. I think it was the starter clutch that was bad to begin with, but, not knowing that, he changed the starter. Then, he talked to a yamaha mechanic and was told about the starter clutch. So he took it apart and changed that.
Now the rest of the story.
He got it all back together and hit the button to see if he fixed the problem. It made a noise and he quickly shut it down. At this point he said he was afraid of doing more damage and just parked it for the last couple months(had already spent over $700 for the starter and starter clutch.)
upon investigation, I think he set the timing off by 180 and when he started it, it bent a valve. the motor will rotate 360 degrees and stop. You can then turn it back to the same spot and it will stop. (Just like a stuck valve on a cub).
He also never changed the ripped and broken gasket, and he never put new oil in the crank(it would have all run out) He was just checking to see if he fixed his problem.
So the bike goes in the shed, and waits till it gets cold outside. Then I will take it to a heated shop, tear it down and see what all is going on in there and get it ready for spring.
Ultimately, I want to trade it for a 250cc or larger scooter. A Burgman would be awesome. I have had 1 hip replaced and will need the other done, so the large scooter is ultimately what I need and want.