Minimum Breaking Strength

Barnyard

Moderator
Staff member
My mail order D rings came today and they are marked 6000 MBS instead of the familiar 5000 lbs. I know that MBS stands for Minimum Breaking Strength so I figure these are just as good. Am I figuring this right?
 
Typically, minimum breaking strengh is determined under ideal conditions in a labratory. Ropes, carabiners, etc. can break at much lower loads, due to real world stress situations. Therefore, the safe working load will usually be less than the MBS.
 
I would say you are safe up to the 5000 lbs.

Manufacturers typically test their products to twice the recommended rating. Reason is, product breaks at 5999 lbs and they get sued.
 
Our local tractor club just had a DOT regulation seminar, so this is still pretty fresh in my mind. All chains/straps/clevises/etc. should have a grade number or WLL (working load limit) stamped or printed on them. If they don't, they WILL BE assumed to be the lowest grade of chain, strap or whatever. For instance, the 2 inch yellow ratchet straps I have all say 10,000 (or so) rated. This is not the working load limit. If you check the tag, the WLL is around 3,333 lbs. Basically, any tie-down device can be as big/strong as possible, but if it is not marked, it is rated at the lowest level.
 
I don't know about all those scientific engineering terms, but my guess is I am safe bolting these to my trailer tonight.
 
Bill go for it. Larry & myself will pick up the good stuff to sell. I know what you mean it is very confusing to the average person.
Be SAFE in you guys travel.
 
Jim Becker":333vuuum said:
grumpy":333vuuum said:
try http://www.cancord.com/BreakingStrength ... ngLoad.asp I had to read it 3 or 4 times before I knew what they were saying
I noticed one confusing statement in that article:
establish the WLL using the formula Minimum Breaking Strength divided by the Design Factor (WLL = MBS + DF)
Looks to me like "WLL = MBS + DF" should say "WLL = MBS / DF".

Jim,
Maybe that is the old fashioned division sign (÷) that did not print clearly.
 
Bill V in Md":3dz04pg9 said:
Maybe that is the old fashioned division sign (÷) that did not print clearly.
Since you mentioned that, I tried blowing it up really big (72 point) and it is definitely a plus sign. However, it could have been a divide sign originally and changed somewhere in the past, like if it was scanned from a paper copy. Confusing as it is now.
 
Back
Top