Maytag engine

Brent

501 Club
:? :? :?

I was wondering if anyone knows anything about a maytag 92. A friend gave me one and I got it running but it fires constantly instead of a hit and miss. I've done just about everything I've found out to do but it still fires just about every stroke. One question left. Does the speed control have to be in a certain position when you adjust the points? ie: full speed, half speed or low speed.
 
The only Maytags I have seen were small engines off washing machines, and they were not hit and miss. Did Maytag also make a hit and miss? These small ones were two-stroke....
 
Rick,
Yes they did make hit and miss engines. They were used for a lot of things on farms in the 20's and 30's. The twins weren't hit and miss engines as far as I know. If you want to take a look at one running go to youtube.com and put in search "Maytag Engines"
 
Bob that would be great. If you want to tell him , here are the things I did or installed.

-installed reconditioned point set used jig to do so. set@20ths
-new spark plug autolite #3095 set@30ths
-cleaned carburetor and gas tank and installed new spring in air valve
-all new gaskets
-checked for any play in crank bearings, none
-gas mixed 32/1
 
Brent, you need to PM hitandmissman on the forum, super nice guy and he lives for that kind of stuff. :D
 
Brent
What kind of a friend would give you something that causes that much frustration? :lol: :lol: :lol:
 
Brent, You need to mix your gas 16-1. Use 30 weight non detregent oil. Probably the reason it is hitting so often is because it is not getting enought gas. Too lean. 32-1 will dry out the cylinder.
 
16:1 would lean it out even more. More oil = less gas = lean mixture.
 
All the manuals that I got on Maytag's say 16:1. I have 6 of these engine's on my shelf. I always had problem's with the reed's getting all gummed up.
 
Oil to fuel ratio should always be mixed as the manufacturer recommends. My statement above doesn't have anything to do with what was recommended.
 
:D :D :D

For whatever it's worth, here are the results. On a 32/1 mix using two stroke oil it would hit just about every stroke, run hot and you couldn't slow it down with the speed control. It was hard to start and would only run for about 5 minutes. I drained the tank and put in the 16/1 mix using 30w non-detergent oil. It started on the second try and ran like it should. Speed control works and it starts now on no more than three trys. It's been cold here and I went out the other morning and it started on the first try. I decided to leave well enough alone.
 
Back
Top