making rawhide

Bob McCarty

Moderator
Staff member
I've never done this before and wondered if there is any downside to soaking a deer hide in a lime solution to remove the hair. It sounds like this would be much easier than scraping the hair off. Also, how long can I wait before scraping off the fat and meat before rotting will start?

Thanks,

Bob
 
Did you salt it first? I know around here they salt them first to stop them from rotting. Then i have no idea what they do with it but I would think some one on here will know. Good luck with and let us know how you made out.
 
Bob. Haven't done this since I was a teenager with taxidermy asperations. But, here goes: Mac is right. You have to salt it first. Let the salt sit on the hide for at least 2 days. This will "quick cure" the hide. The lime soak is a good way to remove the hair. It should be wet and you should soak the hide in clean water first and clean/scrape the hide well before placing it in the lime solution. The lime solution is about a pint of lime to each gal. of water (you can use ordinary builder's lime - "hydrated"). I've heard that hardwood ashes added to the solution (1 pint per gal) speeds up the process, but never tried it. Stir the hide in the solution a few times per day and after a few days, will notice the hair beginning to slip. Leave the hide in until the hair slips real easy. Then take it out and scrape all the hair off. Once clean, you have to get all the lime out of the hide. To do this, soak it in a latic acid (3 ozs to 8 gal water) solution. Or, a cider vinegar solution (8 qts to 24 qts water). Or, a "real good" wash with soap & water a good 2 -3 times. Regardless of which way you use, rinse real well with clean water.

Now. After this, it should be tanned to make it pliable. That's another story ...... :) Hope this helped, some ...........
 
Bob:

When I was a younger man and living in Inuvik, the Innu, Inuit and Dene ladies there had a great way of removing fat, hair and all that stuff that is generations old.

First the fat was removed with an Ulu.. (a round bottomed, very sharp knife), then it was pulled. The outside fur was left intact. To get the pelt pliable.. they would then chew the hide until it was the right feel.

I am not too sure how that would work with a lime presoak though.. :roll: :oops: :roll: :wink: :?: :?: :lol:
rollonthefloor.gif
 
Hi Rudi, I checked with Canadian customs, and they said it was ok to ship the hide across the border. Just send it back when you're done chewing on it!

Bob
 
Little Indy":1ymyv3p7 said:
I think the plains indians used urine and/or brains

Not sure

Richard

Urine provided the salts that preserved it against rotting..

There is a lot of information online about "brain tanning"...evidently the fatty acids in brain tissue were useful in producing a soft, durable product........
 
Back
Top