Its almost springtime, safety first......

BigBill

501 Club
SAFETY FIRST!!!!!!!!

Ok we all been using our clothes dryers all winter now and have you ever taken your dryer apart to clean it out?? The exhaust pipe needs to be cleaned and the bottom of the dryer needs to be cleaned too. We really should do this once a year to besafe. You will be surprised on whats on the bottom of it.

BTW; There is a reward for doing this too, just guess how much change you can find in the bottom of the dryer with a family of 5?? I got $10 worth of change on the bottom of that dryer.

So besafe and clean that clothes dryer and get some extra $$ too.

If your heating with wood I like to clean my chimney every spring. The chimney brush will get the loose cerosote off and the moisture from the rain during the summer will get the rest of the cerosote down by fall. I'm not sure if its the acid rain or just the moisture from the rain but it works. And if you have a stainless steel chimney make sure you clean the cap on top too.

If your thinking of installing a woodstove/coal stove/pellet stove make sure you have plenty of fresh air comming into the house. When I put new outside doors in i fitted two of them on the loose sides so I had plenty of fresh air comming into the house when the heater is lite. You also get better draft too. Remember to invert the seams on the chimney pipe too so the male ends face the stove down ward so the cerosote when heated will melt down back into the fire and get burned up. Another rule of thumb with installing a new woodstove is to have the diameter of the chimney 25% larger than the stove pipe. If your stove pipe is 6" your chimney should be at least 8". This way in a windless situation whern there is very little draft you will still get a good draft. The first clue of having this problem with the wrong size chimney pipe will be that smoke comes back into the house when you first lite the woodstove then the draft gets going as it gets hot. I have seen having the same diameter chimney & stove pipe work in some situations and not work in others too. If your installing a new chimney and woodstove do it right and safe.

Having a smoke alarm/carbon dioxide dector is a must in any household.

The carbon dioxide dector will let you know that something is wrong with your fresh air flow. Carbon Dioxide is a silent killer so besafe get a detector.

I'm posting this because i see so many who are no longer with us because of not doing something correctly. Please besafe, godbless
 
Apropo smoke detector.
Over here on the canadian site, it is now the law that in every level of the house a smoke detector has to be installed, including basement.
Better make sure the batteries are good and the detector works !

Eddie
 
Bill
is there some sort of bin where the dryer collects change and lint? i know to clean the exhaust hose once in a while. when i clean out the exhaust it doesnt take a long time for the clothes to dry.
thanks
john
 
I have heard that dryers are a good % of home fires. I do not use my dryer unless I am home and awake. And I have my fire extingusers mounted on the wall where it can be seen and not get blocked by stuff infront of it in the house and in the garage. And if I am doing "hot work" I keep a extingusher on the floor by where I am working.

Billy
 
I found this out a few years back i had a small dryer fire. Only the lint was burning and i got it out intime i got lucky we were home at the time too. I never expected the dryer to be that full of lint inside of it too.

I was hoping in posting this we could save someone from having that situation too.

With a woodstove or alternative heating in the house besides your furnance make sure you use a carbon dioxide detector too. You need a fresh air vent too so fresh air can enter the house while the woodstove is using air to burn plus the draft is important too. I fitted my outside doors with small gaps near the woodstove area so there is fresh air comming in. You will never noticed the cold air draft comming in when the woodstove is operating too. Besafe your cub needs you....
 
Bill:

Actually, wood is a primary source and not an alternative. Electricity is an alternative heat source and so is Natural Gas, Propane and Oil. The greenie people for some reason seem to think that only electricity has ever existed and everything else is an alternative. That must arrise also from their belief that fake fur has been the primary skin prtection for the Innu, Inuit and other Northern peoples for decades :!: :roll: :wink: :shock: :lol:
hehe.gif


For those of us who heat primarily with wood, the old tymers have provided us with lots of information unwittingly. As newer homes were constructed (learned this in architectual design in college), tighter, more insulation, better vapour barriers, less leakage around the windows and such, the less air infiltrated the house.

In electric heat situations (fine for most city folk or suburbia) this tightening up led to reduced fuel consumption (electricity) as less heat was lost by exfiltration. However, they found tha wood, gas and oil furnace heated homes were suffering massive problems as there was not enough fresh air to allow the jet or flame to continue to burn.

After millions of research moneies were spent, the researchers had discovered that the home from yesteryear, although not as well insulated as our newer homes, were in many cases still hard to heat, but easier to warm up.. mostly because of the presence of .
"Make Up Air"
This led to the practice especially in the north of ensuring that Make Up Vents were installed.

My father-in-law, back in the 70's noticed this problem and solved it by simply drilling a numbger of 3" holes in the header near his furnace. He screened them and put vent covers over the outside to keep the elements and critters out, and his efficiency when up drastically. Because of these observations, when I built my house in 1987, I intentionally installed a 4" screened and vented ABS Make Up Vent close to my furnace. This helped immensely. TA few years later we added another 6" metal Make Up Vent complete with a damper to contol ingress of air and it is positioned directy to the side of my furnace door. he HVAC people has looked at my house repeatedly trying to figure out why I can heat a 36,000 cubic foot of house on 3 levels with an average of 4-4.5 cords per wood/year. The most I have ever burned is 6-7 cords the first 3 years, and this was as a result of way too much humidity in the house resulting from the fresh timbers that were used to construct it.

Oh, and I burn consistently a mix of hard and softwoods. Far more efficient and far more economical. Of course other issues result from this. One must clean one's chimney at least 1 per year... we do it in the fall. Sometimes in the spring depending on what the temps and conditions have been like which is a large factor in creosote buildup. Also, one must have a chimney surround if the chimney is stainless steel and on an exterior wall such as mine was. Thius contributes to more evene flue temps up the chimney, reduces creosote buildup and hence reduces not just the probablility but the actual occurence of chimney fires. Ask me.. :!: :roll: :( :oops: :cry: :shock: :? :idea: :lol:

That's my story and I am sticking to it.

I also agree, most house fires are caused by improper home maintenance and the losses could be greatly reduced by simply changing batteries at DayLight Savings Time in the spring for your Carbon Dioxide, Carbon Monoxide and Smoke Detectors. Also, a pre-planned chimney cleaning schedule on a multi-year basis is an excellent way to ensure your chimney is cleaned regularily. I have a local company who I have dealt with for 20 years to clean my chimney. I used to clean it as well, but no longer can do this with my health.. so A-1 to the rescue.

An old scouting motto : Be Prepared still applies..
 
Rudi, I mainly heat with a geothermal heat pump, and really love it, especially since I can not cut wood myself. I do have a wood circulator in the basement for backup heat though, and right after I put it in I drilled a hole in my header and put in a piece of pvc pipe that runs form the outside to directly behind the air intake for my stove. It definitely makes an improvement. I discovered I needed it when I found that opening a basement window made it easier to start, and it burned better. When I am not using the stove I slip a cap over the pipe to stop infiltration, as well as summer insects.
 
Back
Top