ID sickle mower

I recently acquired 3 sickle mowers for parts and need some help with the ID on some of it. 2 of them are almost certain C22 but the 3rd one is has some unusual connections on the flywheel where the pittman connects and the pittman looks as if it should be round instead of rectangle. Appears to be an oil cup on the connecting point as well, could very well be an older model predating the C22. All the other parts look very similar if not identical to the C22. Thanks for any input. Stan
 

Attachments

  • ID 1.jpg
    ID 1.jpg
    316.6 KB · Views: 10
  • ID 4.jpg
    ID 4.jpg
    287.8 KB · Views: 10
  • ID 2.jpg
    ID 2.jpg
    298.1 KB · Views: 10
  • ID 3.jpg
    ID 3.jpg
    226.4 KB · Views: 10
  • ID 5.jpg
    ID 5.jpg
    252.4 KB · Views: 10
  • ID 6.jpg
    ID 6.jpg
    295.3 KB · Views: 10
Pitman parts from a horse drawn mower were installed by a previous owner. Those parts are way older than any Cub or Cub implement. (It is the shell of a grease cup, not an oil cup.)
 
Pitman parts from a horse drawn mower were installed by a previous owner. Those parts are way older than any Cub or Cub implement. (It is the shell of a grease cup, not an oil cup.)
Thank You, it is confusing because the front and rear mounting brackets and the drive tube assembly look very much like a C22. Could be someone just installed the pitman flywheel and shaft in a C22 tube/mounts. One never knows what we will find. Stan
 
Looks like an old pitman, and pitman ONLY installed on a Cub-22 flywheel.
Thanks for taking the time to comment. Unfortunately have no knowledge of the history of this machine so guessing is all that I can do. I noticed right away that the existing pitman is a piece of 3/4 inch galvanized pipe as seen in pict 2 and 3 so I don't think that would be correct. In addition, the 2 clamps bolted to that pipe that fits on the grease cup as well as the clamp on the end that connects to the head on the cutter bar appear to be made to fit a round object, not rectangle like a normal pitman. The part number on the flywheel matches that of a C22 mower. That and your comment is what led me to the conclusion that it came from a different mower and was just used because it was available and would work for the needed application. Thanks for sharing your knowledge. Stan
 
Back
Top