Hydraulic extension Arm 1A-60 Grader Blade

  • Thread starter Thread starter EZ
  • Start date Start date
E

EZ

501 Club
Hi,
This is a rough sketch of the hydraulic extension arm for the 1A-60 Grader Blade, hereafter called the 'boomerang' or 'whammy bar'.

Can someone please provide the measurements shown in the photo. I have to fabricate one up and would like to get the proper leverage distances.

normal_whammy.jpg
 
Hello EZ. I can do it tomorrow after work if that is okay? I can upload photos with a tape measure and give you numbers too.
 
Mike,
That would be great.
Cut a piece of stock for it today.
Only plan on making it a short one for front lift only for now.
Perhaps some day I can find an original.
 
The two you asked for are almost exact. The rest are close approximations

NOTE: The camera angle makes the ruler marks look off by a 1/8 or so.

(#1) 2 inches
12798859_10207073589452781_269035863966566836_n.jpg


(#2) 1 inch
12804671_10207073588972769_6106184308222530227_n.jpg


These are other dimensional photos

12802973_10207073589092772_2844257728581912664_n.jpg


12799195_10207073589412780_2539934898071542028_n.jpg


12802788_10207073589012770_3210218688229575640_n.jpg
 
Mike,
Can you just wrap that up and send it to Ontario? The Northern part? Ha.

This is a most amazing thing you have done. Above and beyond. I am humbled.
Thank-you.
Take Friday off work.

I was not aware of that slot between the 2 rockshaft hole locations, I will be sure to include it.
 
Mike,
If you are looking in, here is the short bracket fabricated yesterday.
Installed everything today. Nice and tight , need to make some skids.
Worked it for an hour or so pushing melted ice and snow off the drive.
Pushes well, but def need to put my chains on. The other thing that will need getting used to .................The Touch Control action is opposite what the Cub is .
That was fun running into the snowbank and pushing lever forward. It is all good. I like it!

normal_Lift.jpg

normal_1A-60_Blade.jpg
 
EZ,

I don't know if this will get to you, but if it does could you get me the measurements of the piece you made?
Thanks,
James :thanx:
 
James,
I will try to get the measurements for you later today. They were on the original thread but but Mike must have removed them as he has not posted since Jan 2018.
 
fwhiggi":6j382lu3 said:
Would it be possibe to get these pictures
Click to expand...

If you are referring to the missing pics above. That post was put up in 2016 and the poster has not been on the forum in over two years. So, chances of getting those pics are somewhere between slim and none.

Bill
 
You must log in or register to reply here.
Back
Top