Hydraulic Dump Bed?s

carson946

Well-known member
I have a 1971 Ford F-350 DRW, At one time it had a dump bed on it, but when I bought the truck the guy took it off. I still have the PTO,

I've seen so many setups im now lost, In have no clue what to buy!
I had a guy tell me get two Hydraulic Cyl setup, but one guy said don't!

Some people say go to 12volt pump setup, or the scissor setup.

Whats your take on this stuff?

I have been looking at this,

www.piercesales.com/Items.aspx?code=DUMPKIT&key=cat
 
I used to have an IHC 5 ton dump, I purchased a pretty well shot truck and just transferred the dump body on to another truck chassis . The hydraulic unit was mounted to the dump body and I just hooked up the PTO and kept moving. Another one I wish I hadn't let get away.Look around.
 
Since you already have a pto you can go with either electric or pto which ever is the best price. But I like a pto better its simple. You don't have a electric motor to burn out or electric switches and contacts to go bad. And the engine has a lot more power to turn the pump than a electric motor.

I haven't seen strait push cylinder set up on a small truck. The ones I have seen on large truck have to go through the bed and take up room in the bed. You really need the bed to lift 55 Deg or it won't dump clean. My dump trailer only lifts 45 deg and it won't dump in a pile it spreads it out over 15' even stopping and dumping the clutch a few times to jerk it doesn't all come out.

Scissor lifts are fine thats why there are so many of them out there. I have one on my 76 GMC 9500 that I load 2200 lbs in haul and dump.

The big thing is to find a good quality unit that will last. Lift the weight you need as high as you need it. For the best price. I haven't bought a new one so I can't comment on price/quality of new ones.

Scissor lift on my 1950's Ih running gear. The lift needs to be moved closer to hinge on the frame so it will dump clean.

37187_1369567214181_1681757389_703102_2021188_n.jpg


182866_1477235945832_1681757389_888026_5097745_n.jpg


Billy
 
Thanks Vince

I got it for $150 at a auction last spring. The spindles were frozen so it wouldn't turn and I had to build a new deck. All the cross members are held on by angle iron bolted on I have over $100 in bolts alone. Even though it doesn't lift highenough to dump clean it works great for building trails. I pull the hyd back to the detent on the tractor and it lifts and spreads it over 12 to 20 feet and I can turn around and drive over it with out having to stop and spread it.

Right now I am getting about 11,000 lbs of gravel on it.

184257_1484777854375_1681757389_900425_5493733_n.jpg


184257_1484777894376_1681757389_900426_6053484_n.jpg


Thats as high as it will lift so you can see I have to jerk it to get it all off.

184257_1484777934377_1681757389_900427_7648756_n.jpg


Billy
 
Back
Top