house thermostat

JBall8019

Well-known member
Hi Guys,
has anyone here ever change their old thermostat to the newer programmable ones? was it a difficult task? i read the directions on mine and it seems very straight forward. looks like a 30 min to an hour job.
john
 
Bigdog":wboyluxr said:
Piece of cake John.

ditto.gif
Even for me too :!: :wink: :shock: :lol: :lol:
 
Need to know if your thermastat is low voltage or high. Mine is 110 I have to have specal order one. But they otherwise easy.
Jeff
 
You need to know if your old one is a simple make/break 24 volt one. Some systems have much more complicated wiring. It's been a long time, but I think my thermostat requires 7 conductors.

Heat pumps are a different animal.

Just open yours up and check before you go shopping. If it's the 2 wire 24V one it will be very simple.
 
i installed one 2 yrs ago and it works well. we keep it cooler at night and comes back up in the morning b4 work and school.it goes back down during mid-day and back up in the afternoon .
 
gw, i bought the thermostat already. i hope my new one will work for the voltage. i definelty know its not 110v.
ron, did you notice less usage with your programmable thermostat??
thanks guys i hope it will be easy!
john
 
How much savings are we talking here? I have a propane furnace my electric bill in winter runs about $70. I was at the hose shop the other day and I heard this guy talking about a timer for his hot water heater. Works in the same principal, instead of heating the water all the time, just does before the hours you set to use it. Sounds like a good idea, My thermostat has the 2 wires, about how much are the programable thermostats? Brandon.
 
I recently replaced the one on my geothermal heat pump due to the original going bad with a programmable one, and since I don't change the temps at different tiems of the day I don't expect to see any savings there, but it sure does a lot better job of keepign the temperature even. It took aobut 15 minutes to install, and aobut half a day to understand how to program. :lol:
 
Brandon, I'm not sure that anyone can accurately quantify the fuel savings that you would see, because that depends on a lot of factors. Like what temp you keep your house night and day, when it's occupied, average outside air temps, etc. I can tell you that based on previously recorded fuel use, when I first installed mine, it paid for itself ($80) in the first two winter months. In winter, I kept the house at 55 at night and during work/school hours. I brought the house up to 68 from 6:00 am to 7:30 am, and from 3:30 pm to 11:00 pm. No one was in the house during the work/school day. During the air conditioning season, I did something similar, but in reverse. After those first two months, the savings went into my wallet. :D
 
i agree with don. you'll notice a difference but ,there are alot of factors.we keep our home at 58 at night and 68 during times we are at home.just add another quilt on the bed and goodnight :)):
 
If you have a newer furnace with A/C you should have 4 conductors. Red, White, yellow, green. R=24v, W=gas valve/heating, Y=cooling, G=fan. So R to R g to g etc. very simple if you have questions let me know...I prefer Honeywell T-stats above all others.
 
Back
Top