Homemade Axle Straps w/Firehose

  • Thread starter Thread starter Anonymous
  • Start date Start date
A

Anonymous

Guest
For some years now I've had a roll of fire hose like you see rolled up behind glass in big buildings. I've had this idea for some time. I'm going to take 2" DOT strapping and have it sewed onto "D" rings double thick and pass it through the fire hose for chafe protection. Reason for all this is I can't seem to find axle straps that I feel are heavy duty enough and the Cub is a difficult animal to tie down from the rear. I plan to use these through the wheels. Of all my antiques the Cub is by far the most difficult to tie down to a trailer. I do use Rick's brackets on the side of the T Tube for the front ties but the rears are a problem if you are towing with an implement attached. Chain obviously isn't friendly to paint unless you have a bracket and the rear is a hard place to put a bracket that will work for all situations.
 
Bill, I already have a set similar and was going to order longer ones from the same place. But I already have everything I need to make these up and a friend of mine works at Tritex over at the port and already has been sewing my regular straps when they need repair for nothing more than a soda pop. I was thinking of doubling up on the strap so it would be extra strong. My "V" bridle I use to pull cars onto th trailer ( commercially made)is sewn double thick and I like that. However its really all about the fire hose that would offer superior chafe protection. I could order those anyway and still run them through a piece of hose if those ever wore through what they have for chafe protection. The hose BTW is rubber inside and cloth outside. Really heavy woven stuff but is made flat 3" wide.
 
Back
Top