Just bought a Hobart 140 welder, it will not feed wire when welding. Using .030 fluxcore and the wire balls up where it goes into the noodle. Suggestions, ideas :x :x
"Just bought" as in new or used? The feeder tube should be lubed from time to time to keep the friction down. Pull the wire back out and check for deformaties in the end, the result of cutting leaving it mushroomed.
Just went back to the shop, didn't have the gun lead seated in far enough. It welds, it welds :{_}: :-: :{_}: :-:
Thanks for the replies, knew it had to be something wrong with the way I put it together.
Do you have the right size wire for the feeder? I'm not sure of your feeder that you have but is the feeder wheels interchangable? Is the serated feeder wheel on the driven shaft? If your drive wheels are serated and interchangable. I used to the bigger feeders with .032 (250amp)and .062 wire.(500amps)
Did you over tighten the spool of wire on the shaft? It needs to be just snug so it can turn freely. There maybe a spring for tention between the nut and the spool. It won't feed if its too tight.
When i would feed a new spool of wire on any of my MIG's I would remove the nozzle & tip plus cut the tip of the new wire on an angle so it would feed better and not catch on the housing. I would also lay the housing out flat while feeding it.
I would suggest one of those felt clip on's at the feeder to keep the wire clean too. Keeping the feed clean in the housing is very important to avoid feeding jams.