Help.

Jeff Silvey

501 Club
I'm working on my hyd. press to get it to lift the bed at the same time. Do they make a winch system to help with this problem? Now I have to use a floor jack to help move the bed. It it is heavy. I think I have seen something like a boat winch. CRS But it will need 2 barrels so it can operate a cable(s) that can go in opposite directions to do the lifting.

PS: I have tried a come-a-long it won't work.

Thanks
Jeff
 
I have seen them with a boat winch on the side for raising the bed. Here is a picture of one, and if you look closely, there is one cable that goes up the left side, over a pulley and down to the bed, and another (or maybe the same one)that goes down to the bottom across to the right, and then up and over a pulley then down to the bed.

145563_lg.jpg


http://www.northerntool.com/shop/tools/ ... _200332769
 
John *.?-!.* cub owner":yb055m1b said:
and another (or maybe the same one) . . .
If it was done with one cable, once it is clamped properly to both ends, the thing will stay level and it only takes a simgle cable on the spool. On the other hand, if you use a separate cable for each end you are only going to wind 4 or 5 feet of each cable. I don't see any reason they can't be on the same spool.
 
Thanks John. I welded a peice of steel on both ends to act as a handle to help lift the bed. Thanks Jim I will work on that concept.
 
That is one heavy press. Is the press in it's permanent location? What is located above the press - a solid beam to fasten a hoist?

Farmer's jack. Electric wench. Chain hoist.

For no more than I use a press, I wouldn't spend a lot of time or effort figuring out how to raise the bed.

Edit: Screw jack used for changing tires on pickups mounted on top beam.
 
Back
Top