heater core

Jeff Silvey

501 Club
I'm trying to replace the hearter core in a GMC Jimmy w/o a manual :oops: :cry: :( I went of seach engine with no sucusses. Can any body help me with this problem. I have done everything & taken every bolt out w/o taking a hurst tool too the dash. Yes Steve B I do know where to get an hurst tool. Everything is loose but won't fall out. I get a little up set a may age. Maybe someone on this wonderful site will help me. GRRRR!!!!!!
Thanks :)
Jeff
 
Jeff, do you have the replacement core there? Perhaps it will show you something that you can't detect with the existing one.
 
BD:
No I can't get the stupid thing out. Frustrating for this old guy. I can't get all the bolts, screw you name it out or off. Is there a web site or do I have to spend some money to buy a manual :?:
Jeff
 
I replaced the heater core in a 1988 Suburban several years ago. It must have been the first part on the assembly line and the entire vehicle was assembled around it. I'll try to find the reference book and get the vital facts to you later this afternoon.
 
Jeff,

I sent an attached document to your E-mail address on the removal procedure for the heater core for a GMC Jimmy. I had to send it in Word. If your P.C. does not have the program you can go to Microsoft and they have a converter on line or you can go to http://www.openoffice.org/ and get it free.

I have removed those heater cores by; taking the radio out, the door in back of the glove box, the upper bolts in the defroster ducts and the bolt on the right lower side of the instrument panel and pry out. Other wise follow the step by step I sent you.

Hope this helps and let me know if I can help in any other way. I’m going to be gone until Friday or Saturday.

Jack
 
Jeff, I just finished installing a heater core in my 91 S10 pickup. It should be about the same procedure. I used the info I found on a Chevy website to help me. Believe me, it did help. By the way, to get to the screw in the upper right part of the heater box, you will need a wobble joint and a couple of long extensions. Check out the link for all the info. Hope this helps. Larry

http://www.sytyarchives.com/howto/viewa ... e_controls
 
Jack's got that procedure just about right. Set aside the better part of a day to do the job.

Had to remove glove box, loosen the radio and ashtray, unbolt the evaporator from under the hood and remove an odd assortment of nuts and bolts from a dizzying array of hard to reach places just to get the duct assembly out of the vehicle. Then the duct assembly had to come apart to extract the heater core, that contraption is GM's version of the Rubik's Cube. May the force be with you.
 
I replaced the one in our 94 chevy dually, it was a booger, broke the bottom. It kept feeling like I had missed a bolt. Go under the hood on the engine side of the firewall, and loosen the bolts that actually hold the heater box to the firewall. Then you can pull out the whole assembly from the firewall, and the bottom should fall right off. The heater box bottom on it had a lip that was actually attached to the firewall side, I guess they put the whole assembly in the truck at once. :D Brandon.
 
WELL
I told you all I would be back. It's not going to plan :( . Dash won't come out as per instruction. Half of the cover can out not pleased :x . I'm a little frustated :( . But being patient. Well going to a football on Sat. Will get back to it on Sunday. Wish me luck. Is there any more places to get info :?: What everyone has given to me so far is close but no cigar.
Thanks for the help.
Jeff
 
Back
Top