I have a 2012 Chevrolet Equinox with the 2.4L Ecotec 4 cylinder engine. Two weeks ago, the timing chain jumped a couple of teeth at 83k miles (lone P0016 diagnostic code). I first replaced the crank and cam position sensors to no avail, then went ahead and replaced the timing chain. I did lots of research before starting while trying to diagnose. What I have learned is very concerning and despite dropping a large chunk of money and time on this car over the past couple of weeks, I'm going to get rid of it ASAP.
This engine has direct fuel injection and has a high pressure fuel pump driven directly off the intake cam. When the seal goes bad, fuel mixes with the oil and dilutes it. This then leads to premature timing chain and guide wear. It also leads to piston ring failure and scuffing of the cylinder bores. With the extra blow-by, an excessive amount of water accumulates at the end of the PCV in the intake plenum. There is a small well in the plenum where the PCV discharges to. If parked outside in cold weather, the water freezes, the PCV plugs with ice, and the crankcase pressure blows out the rear main seal of the engine.
In my case, the timing chain guides and tensioner were fine, but the chain had stretched ~3/8". When I took the intake plenum off the car to start diagnosing, I poured 1/3-1/2 cup of water out of it. Luckily it gets parked in an attached garage overnight and generally stays above freezing; so the seal is intact for now.
If you have a GM product with the 2.4L Ecotec, listen for excessive noise at the passenger side of the engine while it is running. It is an interference engine and will bend/break valves if the timing chain breaks or jumps more than a few teeth.
Also take off your intake plenum and see if any water runs out of the PCV hole. A lot of people are rerouting their PCV to a catch can/bottle so that they don't blow out the rear main. It appears that there is no long-term fix to these issues. I've seen many reports where a dealer-installed replacement engine exhibited the same issues at low mileage.
This engine has direct fuel injection and has a high pressure fuel pump driven directly off the intake cam. When the seal goes bad, fuel mixes with the oil and dilutes it. This then leads to premature timing chain and guide wear. It also leads to piston ring failure and scuffing of the cylinder bores. With the extra blow-by, an excessive amount of water accumulates at the end of the PCV in the intake plenum. There is a small well in the plenum where the PCV discharges to. If parked outside in cold weather, the water freezes, the PCV plugs with ice, and the crankcase pressure blows out the rear main seal of the engine.
In my case, the timing chain guides and tensioner were fine, but the chain had stretched ~3/8". When I took the intake plenum off the car to start diagnosing, I poured 1/3-1/2 cup of water out of it. Luckily it gets parked in an attached garage overnight and generally stays above freezing; so the seal is intact for now.
If you have a GM product with the 2.4L Ecotec, listen for excessive noise at the passenger side of the engine while it is running. It is an interference engine and will bend/break valves if the timing chain breaks or jumps more than a few teeth.
Also take off your intake plenum and see if any water runs out of the PCV hole. A lot of people are rerouting their PCV to a catch can/bottle so that they don't blow out the rear main. It appears that there is no long-term fix to these issues. I've seen many reports where a dealer-installed replacement engine exhibited the same issues at low mileage.