Gearbox question
- Thread starter brucep
- Start date
George Willer
501 Club
Pretty much the same, but second gear ratio may be different. Naturally, the input shafts are different.
I have a cadet gear case in one of my F-Cubs.
I have a cadet gear case in one of my F-Cubs.
Several months ago someone posted a picture, on the Cub forum, of an original Cub Cadet advertizement that showed a Cub Cadet and a Cub and if my memory serves me correctly IH made the statement in the ad that the Transmissions were identical in both tractors. I wish I could find that post.
George Willer
501 Club
I don't have the gears handy to compare them, but I do believe the second gears are different until shown differently, notwithstanding the text by an advertising writer.
I did compare brake drums since I could lay my hands on one of each. I CAN say with certainty that the F-Cub drums fit on 1 1/2" shafts in the final drives, while the Cadet's single drum fits a 1" shaft ahead of the transmission. I would not claim that they are the same, as the ad writer did.
I did compare brake drums since I could lay my hands on one of each. I CAN say with certainty that the F-Cub drums fit on 1 1/2" shafts in the final drives, while the Cadet's single drum fits a 1" shaft ahead of the transmission. I would not claim that they are the same, as the ad writer did.
George, Cub Cadets used 16/36, 17/35, or 19/33 tooth second gears, depending on the the model, and I believe the Cub used 16/36 or 17/35, , tooth gears (and maybe others) depending on the serial number. The Cub Cadet in the picture is a so call Original, or first model, and it had a brake drum and band brake on the left rear axle, that was the same basic drum (different size hole for the axle) and brake band as the Cub , like the author stated. Beginning with the next model Cub Cadet (70/100) the brake became a wet brake in the gear reduction housing on the front of the transmission like you said. The transmission case is the same basic case, and the early Cub Cadets still had the "fill to" plug on the left side of the case even though the Cub Cadet required 7 pints of oil/Hy-Tran. They had thier own "fill to" on the right side of the gear reduction housing, and the owners manual reminded you not to use the one on the left side.
George,
Here are a couple of pictures from a member at the ihregistry site, one with the "Original" brake setup. Like Paul said, they only used this in one model, from 1961 through 1963. Good thing too, because, although it's a good brake, one wheel is kinda scary sometimes and you can just figure on goin' for a ride every now and then.
When I am at my buddies cabin and we're bringing stuff off the hill, he has a trailer ball on his original and if it has any weight in it we'll hook it to another tractor with a chain from behind, just in case.
Here are a couple of pictures from a member at the ihregistry site, one with the "Original" brake setup. Like Paul said, they only used this in one model, from 1961 through 1963. Good thing too, because, although it's a good brake, one wheel is kinda scary sometimes and you can just figure on goin' for a ride every now and then.
When I am at my buddies cabin and we're bringing stuff off the hill, he has a trailer ball on his original and if it has any weight in it we'll hook it to another tractor with a chain from behind, just in case.
