Gas Cans & Replacement Spouts

On my big 5 gallon blitz, I have become an expert on using the safety spout to wedge the can into the fuel hole. The fill hole rim pushes the lever in so I dont have to. SO I just set it and forget it (except watching it to make sure that it dosent overflow).
 
John:

Thanks for that tip. I have a lot of difficulty now lifting a 20 liter or 5 gallon gas can. It is almost out of my range of ability as of late. I haven't found anything that would make it easier for me. I am hoping I can get these up here. We will see.. and will update when/if it gets here.
 
Rudi, I know you are a hard sell.... but you can use the No-Spill with ONE HAND.

Hopefully I have my friend at Fort Adams to replace those :censored: Blitz cans. Purely painful to fill the brushcutter, they leaked so bad it was just easier to take the nozzle off :evil: .

I did see that TSC had one size No-Spill on the shelf.

They are stout and trail tested by the Buzzard!
DSCN4712a_zps1f4e4e83.jpg
 
Rudi - I can get a 1.25 gallon one for you locally if needed and I could send it to you. I use the 1.25 for 2-Cycle gas for our line-trimmers, chainsaws and pole-saw. Never spill a drop anymore. I can also get 2.5 gallon ones which we use for lawnmowers and smaller 4-Cycle engines.
 
You must log in or register to reply here.
Back
Top