Ford Focus Jack

Bus Driver

501 Club
Bought cheap at a yard sale a scissors jack, from an estranged wife getting rid of her husband's stuff.
The numbers on it identify it as a Ford Focus jack. This eBay listing is not the exact number on the jack but looks the same.

http://www.ebay.com/itm/FOCUS-00-04-SPA ... Mx&vxp=mtr

The captive handle is 5/16 diameter with a washer welded on the side. I suspect that the washer was for holding down the jack while stored in the car.
Not sure how this was intended to be used. The captive handle is quite awkward to use when the jack is still low/collapsed. Is this all there is originally? I have ideas about modifying it to better suit my needs, but perhaps someone can tell me how this was intended to work?
 
That's all there is to it. They're a real pain when down low and not a whole lot better when extended. If I had it for around the shop I'd cut the handle off and weld a nut to it for use with a ratchet or impact wrench.
 
Thanks for the information. One idea is to use a piece of 1/4" galvanized pipe to slide over the rod, notch the end of pipe to accommodate the washer. Then extend the pipe to a crank handle. That leaves the jack unaltered, affords a slip-on extension that works like a "normal" jack.
 
Back
Top