This is one of my more favourite off-topic topics. I have been heating with wood as a primary source of heat for the last 22 years I guess. Prior to that we have heated with electricity, natural gas, oil and propane ranging from my home town of Timmins in Northern Ontario, to Ottawa, to Inuvik NWT, Alert NWT and Lahr Germany. Growing up my grandparents heated only with wood. I have found that there are primarily two types of heat. Warm moist heat and warm dry heat. Natural gas, propane and oil are fossil fuels that provide warm moist heat, primarily because they are used in forced air systems. Electric although it also may power forced air systems, predominantly is used in radiant heat which is a dry heat. No convection no moisture moving around to negate the dryness or reduce the amount of energy needed to provide the heat necessary. Radiant heat is by far less efficient than moving or forced air heat.
Wood is probably one of the best, most environmentally sustainable, comfortable and affordable forms of heat that we have today. It is the epitome of warm moist heat be it either in a forced air system, or radiant as in passive wood stove systems. It is also one of the oldest known means to heat a home.
Ok, so much for history. Here is the numbers for us here.
I have a 1200 sq ft 3 level home which equates to 36,000 cubic feet of building to heat. We have a Kerr Scotty DB2 Forced Air Wood Furnace with a capacity of approximately 70,000 btu's. Our backup is a 30KW Electric Furnace .. but we have only used it once when we set it up and haven't used it since. Average winter temps run in the -20 to -30 Celsius range. Winds average around 30 to 60 km/hr with gusts in blizzards to over 100 km/hr. To say the least, winters can be cold, they are also not short. Heating season can start as early as September and definitely full tilt by mid October and can last until May. Heating season lasts at an average of 7 months of the year. Insulation counts for a lot in climates like ours. Our house is not exactly R-2000 as when I built it, R-2000 homes were not common. However, it is built with 2x6 walls fully insulated along with exterior weather wrap under the siding, taped joints, sealed windows etc., with make up vents to balance the pressure and provide sufficient fresh air needed in a forced air system. Houses with less insulation will require substantially more energy to heat.
We use approximately 4 to 6 cords of wood per year to heat our home. I have yet to burn more than 6 cords except the first year when the house was still wet from construction. We burn a combination of soft, soft hardwood and hardwoods. One should never burn just hard or just soft. A good mix provides the best most even heat and also provides for sufficient temperatures to ensure the minimum of creosote build-up in the chimney. I usually build a hot fire in the morning to eliminate any creosote buildup from the overnight fire which is usually a couple large hardwood logs. They burn slower and provide consistent heat for hours. A hot fire will bring the heat up quickly, clean the chimney and start a good bed of coals so that the daytime fires can be built with a mix of woods to provide a medium hot fire that will last all day.
Normally we harvest 10 to 12 cords per year. This usually gives us a 2 year stockpile. Keeping wood for 2 years, as long as it remains dry will provide good heat value per/cord. Any longer and the wood begins to lose its heat value. Keeping wood dry, does not necessarily mean keeping it covered or indoors. Wood has bark and bark is woods natural protection. l By properly stacking wood so that the top layer of the stack is bark side out, then the ability of water to permeate the pile is reduced substantially. By having good air flow, the wood will also stay dry.
Oh.. good firewood here runs between $150.00/cord (short as in 8 foot) or up to $225.00 for split (long cord). Still way cheaper than a tank of oil.