Final drive torque spec's

[grcox]

Replacing left side final drive, case bolt holes are cracked cannot connect draw bar. Have to get this fixed for the Buckeye cub tug 2009.
Need the torque spec for the one & half inch castle nut for the lower stub shaft. if not one what do you all do to put proper loading on bearings?
Also any advice and concerns please bring all.
Thanks
Rusty

 

[Bob McCarty]

See if this answers your question: http://www.farmallcub.info/manuals/gss- ... 007-07.jpg

Bob

 

[Rudi]

Rusty:

Replacing left side final drive, case bolt holes are cracked cannot connect draw bar. Have to get this fixed for the Buckeye cub tug 2009.
Need the torque spec for the one & half inch castle nut for the lower stub shaft. if not one what do you all do to put proper loading on bearings?
Also any advice and concerns please bring all.
Thanks
Rusty

The Blue Ribbon Service Manual - GSS-1008 -Specifications would be one place to check for the Specification Values.

Another good manual to check would be the GSS-1411 - Service Manual for Cubs and Lo-boy Tractors Revision 1 and Section 7 - Final Drive and Brakes and I think Page 07 would be the ticket.

 

[grcox]

Thanks to both of you, went back together slicker then snail snot! :big afro: