Yesterday was a battle I didn't plan. I had a lot to do and the machinery was putting ME to the test, instead of the other way around. The 111 is a hand me down from Dad. It has a newer engine, but is a smaller machine with a 38" deck. I've got four acres of not-so-level land to mow, and it just wasn't getting it done. It gets hung up and stuck and just sets too close to the ground. It would be great for a lawn. But, what I have is not what I categorize as a "lawn".
Sooo, I go get the 112. It takes off like gang busters! Bulldozing through tall grass with its 46" deck. Then, it starts starving for fuel. I limped it up the hill to the garage and start trying to figure out why it isn't getting fuel. The fuel strainer was clean as a pin. So, I go back on the 111 until the 112 cools off enough for me to work on it.
I finally figured out that the 112 is vapor locking. The fuel line goes through the engine shroud. Once I rerouted it outside of it, it quit the vapor locking. So, I take off again and then the deck starts slipping. I go back and have to adjust the clutch on the PTO. Finally, the last 20 minutes or so I got to have smooth sailing on the 112. But, it needs some more work. I discovered the carburetor is cracked on the air intake side.
What's this got to do with a cub? The whole time I was fighting these cantankerous contraptions I was talking to myself saying "I'll be glad when I get enough money saved up to buy me a CUB!" This place was so much easier to take care of when Dad had is cub. I could mow it in an hour instead of four! :x
My current plan is, this coming winter will be spent working on a Cub and getting it ready for next year's mowing season. The 111 will remain for doing trim mowing around the house, and the 112's fate is undecided. I may tuck it away and restore it in a few years. When it runs, it runs good.
Ahhh, the joys of using old machinery! I know a cub will have its own faults to deal with as well. I do enjoy "Fighting" with my old machines. I guess I"m just nuts!
Sooo, I go get the 112. It takes off like gang busters! Bulldozing through tall grass with its 46" deck. Then, it starts starving for fuel. I limped it up the hill to the garage and start trying to figure out why it isn't getting fuel. The fuel strainer was clean as a pin. So, I go back on the 111 until the 112 cools off enough for me to work on it.
I finally figured out that the 112 is vapor locking. The fuel line goes through the engine shroud. Once I rerouted it outside of it, it quit the vapor locking. So, I take off again and then the deck starts slipping. I go back and have to adjust the clutch on the PTO. Finally, the last 20 minutes or so I got to have smooth sailing on the 112. But, it needs some more work. I discovered the carburetor is cracked on the air intake side.
What's this got to do with a cub? The whole time I was fighting these cantankerous contraptions I was talking to myself saying "I'll be glad when I get enough money saved up to buy me a CUB!" This place was so much easier to take care of when Dad had is cub. I could mow it in an hour instead of four! :x
My current plan is, this coming winter will be spent working on a Cub and getting it ready for next year's mowing season. The 111 will remain for doing trim mowing around the house, and the 112's fate is undecided. I may tuck it away and restore it in a few years. When it runs, it runs good.
Ahhh, the joys of using old machinery! I know a cub will have its own faults to deal with as well. I do enjoy "Fighting" with my old machines. I guess I"m just nuts!