I brought a TO-30 back from the dead last fall and have it running great again. One of the issues I have yet to resolve is the fender bolts. One side the bolts are snapped and there are no nuts on it but they are in tight and the fender doesn't move and pounding on it with a hammer doesn't do anything but hurt my ears. The other side has one bent bolt keeping the nut in place and the other is unmoveable. All bolts heads and nuts are square so sockets are out of the picture.
So my question is how do I get them out to replace them? Without replacing them I can't install stabilizer bars for the 3 point. I was thinking about cutting them out and pounding the new ones in place but there has to be an easier way without torching them and cooking the paint off.
Any help would be appreciated!
-Ben
So my question is how do I get them out to replace them? Without replacing them I can't install stabilizer bars for the 3 point. I was thinking about cutting them out and pounding the new ones in place but there has to be an easier way without torching them and cooking the paint off.
Any help would be appreciated!
-Ben
