Farmall Cub Bolster/ Steering Housing Removal

[RunningRed]

Hey fellas I again made another post to keep everything organized. I decided to remove the steering housing from the tractor to replace the gaskets and repaint it and the bolster. What is a safe way to remove them? I tried to do some research but I'm confused and a little overwhelmed to how it all comes apart or in what sequence they should be removed?

 

[staninlowerAL]

If you want to replace the gasket between the 2 sections you can remove the pin that secures the front axle tube and the axle will drop out so the bolts that hold the lower piece in place can be removed. There's a couple of dial pins there also. This is after the steering arm is removed. No need to completely remove the bolster upper section from the engine unless you want to get to some hard to access areas for cleaning and painting. JMHO Stan