Evercoat Products - Finish Glaze or Icing

  • Thread starter Thread starter Anonymous
  • Start date Start date
A

Anonymous

Guest
Anybody using these products currently? Tell me about your issues with curing in low-temp conditions? THe manufacturer was no help...and its difficult to find people using this product in auto work.

Thanks
 
Don - they offered me no help. THat was my first go-to place. I need more indepth knowledge from guys using it for the same purpose...refinishing pitted metal.
 
What do you mean by low temp? How low? Most fillers that Ive wroked with do not cure well below about 50 degrees. If Im doing something like a hood, Ill stick it in front of the furnace outlet for a few minutes to "warm" up the metal. Dont get it to hot or the filler will cake up immediately. Frank
 
You shouldn't use fillers in cool temperatures, you may have problems with moisture, as well as not curing properly. I use USC Icing, to fill properly cleaned rust pits, it's really nice stuff. Be sure to buy it from a source that sells a good bit of body shop supplies, because after a few months, it will begin to thicken and becomes more like bondo.
 
Back
Top