Encapsulated Nuts

BIGHOSS

501 Club
Encapsulated is not the correct description, but I could not come up with another one. However, the question is "How can a nut be attached permanently to sheet metal, as for the hood support"? I know it can be welded, but I don't want to burn my purty paint. I have tried epoxy with no sucess. Does anyone make a nut that can be braded to the sheet metal?
 
Ricky, I have looked at the "Rivnuts". I was hoping to find one that mounted on the inside without being seen from the outside. Having a career in the aircraft industry, I was exposed to several types of hidden or blind nuts. But I don't remember one that looks like what I want.
 
clean the paint of where you want to attach the nut, and use JB Weld. Are you talking about a round nose cub, I cannot think of a nut for hood support on the outer sheet metal there. Or, were you referring to where the doglegs attach to the hood?
 
John, I am thinking of the (4) truss head 1/4-20 bolts that attach the rear of gas tank/hood to the support. Mine has (3) nuts projection welded to the hood with the other nut welded to the wire cable support on the RH side. Also on the square nose, the top front and side that fastens the hood to the supports. And on a square nose, the grille attaches with (4) bolts to blind nuts.
 
On the McMaster Carr link, look at the ones called "Rivet nut inserts". They are generally installed with a setting tool but it's easy to improvise.
 
Back
Top