Jim Hudson
501 Club
Jim, I don't know how to get this on the forum, but I think you do. This came with the tractor when I got it, but I don't think it belongs. Do you know what it's for? Elmer
.jpg)
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Elmers blade
- Thread starter Jim Hudson
- Start date
Jim Hudson
501 Club
Home made with 3 blades off some scrape on 2 plow beams with rear cultivator spring rods to lift it. I don't see how he hitched it up.
S.H.A.F.T.
Well-known member
Jim, I think you nailed it. If you look closely, it appears as if the blade is actually made up of three cutting edges off a larger snow plow.
S.H.A.F.T.
S.H.A.F.T.
danovercash
501 Club
Probably bolted plow beams to wheel housings. For another use for plow beams , check harrow on my site. Dan
Elmer Fields
Active member
Jim, I belive your'e right about the blade. I've had it for years but I never got around to really looking at it or trying to hook it up . When it warms up a little i'll try that. In the mean time i'll measure the plowshare width & see if I can figure where it would hook on the tractor. I also have 2 discs & other stuff i'll send pictures of.
Elmer.
Jim thanks,
Elmer.
Jim thanks,