Drilling Masonary

What is (are) the tricks to drill into concrete. :?: :?: :?:
I have poured concrete walls in my basement. I am working on my next project area,
http://s16.photobucket.com/albums/b46/v ... om/before/
and have to mount some framing boards onto the concrete walls, about 32 ft of it. I got about 15ft done and then i burnt two new bits :x :x :x and i was done for the day. I was frustrated :cry: :cry: :cry: so i knew better than to continue.

John

I am guessing it may have something to do with the drill bits (Vermont are they any good). I was using a GE hammer drill 1/2" drive
 
Don't waste your time with those light drill motors that have hammering action and use a round carbide tip drill. Get something that has some real punch with some kind of bit that uses a retainer.
 
you could use a hilti gun. it uses .22 shells and you shoot the nails into the concrete. it's pretty fast, lous but fast.
 
Definitely us a hammer drill with a good masonry bit. Go slow since speed can burn up a bit quick. I don't use hammer drills much so I just borrowed my friends.

Also, make sure you know what is on the other side if you are drilling through the wall.

Here is a short safety film I used in all my safety meetings with my maintenance guys. I advise everyone to watch this for tips.

Drilling Through Walls Safely
 
a couple things come to mind, if your just hanging shelves the g.e. should do the job. use a good hard bit and make sure you have a side handle on the drill. let the drill do the work, if it is throwing dust then it is working,after hammering a bit pull out and clear the hole of any debris that may have accumulated. some times it may seem slow but there is a rhythm . if you have poured walls they are probably 5,000 psi or better. that's hard. http://www.google.com/aclk?sa=l&ai=CDJS ... index.aspx
 
Couple of items. Vermont American - ain't good quality. You will need to spend some money and get really good quality drill bits. I do not buy Vermont American for anything.

I'm not familiar with the GE hammer drill. But the bigger, heavier, more expensive hammer drills work much better. If you can borrow a bigger drill, you will be amazed with the difference.

The biggest problem when drilling cement is hitting a big rock. A quality masonary bit will drill or break through with a bit of effort.
 
I have used the 22 caliber stud guns, home hammer drills with masonry bits, and commercial rotary drills. If you have a lot of them to do, and are having trouble with the rocks in the concrete dulling bits I would suggest renting a commercial one form your local hardware store. My 22 caliber would hit a hard rock and bounce or not seat all the way. Then you had a worse problem.
 
I used the homedepot drill bits i think they were the VT stuff. I purchased a makita hammer drill and even used a 2x4 to pry on it to make it drill thru the stone into the cememt too. I did wearout bits but they did last for a few holes. I was using a 3/8" drill for 3/8" thunder studs or red heads what ever you call them. Some holes are easy to drill and some are much tougher.

You can also rent a better/larger hammer drill from homedepot too i think its $50 a day i've done that too.
 
I have found Dewalt bits to work very well, they are spendy, but I have done as many as 30 3/8 holes into concrete and have had plenty of life left in the bit. Our local Ace rents hammer drills, they are all milwaukee, for $35 for 3 hours and even provides the bit!
 
Back
Top