Does anyone else get this fussy

cowboy

501 Club
When changing their brakes :?:

I do not know why but I always clean up and pain all my brake parts when I change the brakes. I just guess I hate it when I take the brakes apart and everything is all rusted up. These are off of a 1993 ford festiva. I had to use a chipping hammer to get all the rust scale off of it. The guy my dad got it off of thought the trans was going bad. He had just put a new clutch, brakes front axles and CV's. Well he had gotten rust in the wheel bearings when he put the rotors on it and wiped out the bearings. Before you say it. No the paint will not burn off I have been doing this for 22+ years. I just use engine enamel spray paint. The paint lasted 10 years on my 91 explorer I would just slide a new set of pads in every two years.

IMG_0142.JPG


Billy
 
Since I get over 100K miles per front pads and seldom need rear brakes, it's not worth the effort for me. But I do notice that some vehicles use metal alloys in their braking systems far more prone to corrosion than others. It's a good idea!
 
Carl what kind of car are you driving :?: My explorer needed front pads every two years no matter how much or little I drove. Although I always changed them before they hit the rotor so I could just slide a new set in. I think I have only replaced the rears twice in my life.

Billy
 
Most of my driving is highway so I cover lots of miles without ever touching the brake pedal. I tend to have problems with the calipers siezing by the time I need a second set of pads, regardless of the vehicle make. My lovely wife drives mostly in urban traffic, brakes are shot every 30-40K on her car.
 
Cowboy, I used to be almost that particular, however health and age have made me much less so. I am like Carl, on the vehicles I drive having to replace pads or rotors is rare. On my daughter's cars however, it is another story.
 
If you buy good stuff it should last.Wish I was selling parts!!!1993 Festiva is a good choice execpt to find parts.I like the gas milage they got.Keeping stuff cleaned up helps out.Kevin 8) 8)
 
Carl I could get the rotors to last that long but the pads were always gone after two years. Although thinking about it now I used to run the cheapest pads I could get because I knew they were not going to last. I have changed somewhat now I get the premium pads now I feel they make the brakes feel better and they don't wear the rotor as bad.


John your still a kid :wink: How far are you from JP's I am planing on driving down there tuesday. I hear you on not beaning able to do what you used to do. I am going to get a 1000 loader for the 100. I can't lift as much as I used to. Its hard but I guess I have to start working smarter now.

Kevin you are right most everything on that car you have to order. And thats if it is still avable. Good luck with the job hunt.

Billy
 
Cowboy, I am about 60 miles due north of JP Tractor, maybe we can get together for lunch, or depending on the rout, maybe ride down there together.

I would love to have a small tractor with loader, something the size of a cub and 100, or a Power King, but financially I do not see it in the near future. However this one is sitting behind my house, all painted up and waiting for me to rebuild a set of cylinders then reinstall it on EJ.

loader%202b.jpg
 
Back
Top