Cub - Cultivator Spring Tooth Assembly No97 - Measurements Wanted to Build

[Cat-astrophe]

Hello All
I am looking to make some Cub-144 Cultivator No97 Spring Teeth Assemblies as they are virtually unobtainable here in NZ and the freight from USA would be prohibitive.
Would someone be able to take some measurements of the assembly and post for me please? I have written up the measurements that i am looking for on the attached diagram from the parts book.

1. Dimensions of the square bar stock that the assembly is made from.
2. The length of the assembly
3. The distance between the end of the assembly and the centre of the round mounting bar
4. The gap between the two bars.

5. It would also be very helpful to know the dimensions of the spring cultivator ie width and thickness of the spring steel. But this is a nice to have.

Thanks for help in advance.
Hudson Biggs
Dunedin, New Zealand

 

[Mike Mueller]

Hello All
I am looking to make some Cub-144 Cultivator No97 Spring Teeth Assemblies as they are virtually unobtainable here in NZ and the freight from USA would be prohibitive.
Would someone be able to take some measurements of the assembly and post for me please? I have written up the measurements that i am looking for on the attached diagram from the parts book.

1. Dimensions of the square bar stock that the assembly is made from.
2. The length of the assembly
3. The distance between the end of the assembly and the centre of the round mounting bar
4. The gap between the two bars.

5. It would also be very helpful to know the dimensions of the spring cultivator ie width and thickness of the spring steel. But this is a nice to have.

Thanks for help in advance.
Hudson Biggs
Dunedin, New Zealand

Its 3/4 square x19” long with 5/8” space
The 1 1/4” rod is 10”3/4 , 14” from outside of round end to center of rod
The rod has a 5/8” wide by 3/4” deep cut on the one end to weld in place
Hope that helps

 

[Cat-astrophe]

Its 3/4 square x19” long with 5/8” space
The 1 1/4” rod is 10”3/4 , 14” from outside of round end to center of rod
The rod has a 5/8” wide by 3/4” deep cut on the one end to weld in place
Hope that helps

Hello Mike
Thank you for posting these measurements. This was exactly what i was after. Appreciated.
Hudson
Dunedin, NZ

 

[Cat-astrophe]

Hello Mike
Thank you for posting these measurements. This was exactly what i was after. Appreciated.
Hudson
Dunedin, NZ

Hello Mike
Thought you might be interested to see what you assistance resulted in! Attached is pic of the cultivator bars that i have manufactured with the dimensions that you kindly provided.
I cheated a bit, rather than bend then out of 3/4 sq bar, i had them profile cut. I still have to dress them up, and weld in the 1 1/4" shaft.
Thanks for your help
Hudoson
Dunedin, NZ