cub 252 cultivator
- Thread starter t jackson
- Start date
Are you talking about the U-bolt that holds the tool bars to the attaching bars? Do you have one to use as a pattern? Get a threaded stud with 5/8-11 threads on both ends and make one. It will probably take a stud about 9 or 10 inches long. You will need to heat it to bend it properly.
yes that is the u bolt,jim
Assuming you have a Cub-252 and not the later Cub-252A, that U-bolt is almost more accurately described as a V-bolt. There is a 90 degree bend in the middle and another 45 degree bend on each side. I think my bent stud suggestion would work.
This is probably longer than needed but looks like it has long enough threads to work okay.
www.mcmaster.com
I'd probably have to get 2, one to practice on and one to use.
McMaster-Carr
McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.
Don McCombs
501 Club
He lives in horsey country and probably knows a blacksmith or two.This is probably longer than needed but looks like it has long enough threads to work okay.
I'd probably have to get 2, one to practice on and one to use.McMaster-Carr
McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.
