Collecting??? something different....

BigBill

501 Club
I have started collecting single cylinder engines from the 50's so far. I picked up two wisconsin one lungers today. They have wico mags and zenith carbs. I believe there 9hp but look more like boat anchors.(heavy too) One has a lever for a clutch on a reduction gear box. The other just has a reduction gear box. I can't wait to get to play with them. I look forward to rebuilding and restoring them too.

I also picked up today a smaller kolher 1 cylinder that looks like a 5 or 6hp that has a starter / generator on it too.

I have an older B&S Model 9 too.

I can see this getting costly parts wise too but they take up less room than tractors too.
 
May be a bit costly but look at all the fun your gonna have. Satisfaction too. Keep up the good work till ya run outta $$$$ :D Grump
 
Bill:
I have been collecting Hit &misses for a few years and other engines. I'm like you engines do take up less room but tractor are more fun.
Jeff
 
I like tractors too but i'd like to do a little of both. There's just something about hearing that magneto bang away when she idles. My next farmall will have a mag too. So you know were my next s/s check is going....My next pension check is going for a farmall H i hope it works out 12/1.
 
Speaking of old one lungers, one of my old High School buddies picked up one of those ancient loooong stroked washing machine engines. I remember that thing sounding like an idling locomotive steam engine.
Cha-choong.........cha-choong........
-Ken
 
gas powered Maytag engine?? Kick start?

I played a little with my newly required wisconsin egines today and found out they have compression. Then i hear the mag fire when i turned it over more. I can't wait to get it running....

Ever see a Shaw Du All tractor?? Since i have an extra cub tranny it sounds doable.... I also have a extra clutch/drive shaft from a cub cadet too. I'd like to power it with a wisconsin engine.
 
Back
Top