Butter churn

Jeff Silvey

501 Club
I have an old wooden butter churn that belonged to my folks. I need some help on making a handle and the bottom part that goes down in the cylinder. Oh I forgot the top. What wood would for this project. If someone has any picture and measurements it would help.
Thanks
Jeff
 
"Foxfire 3" ISBN 0-385-02272-7. The Anchor Press, copy right 1974, 1973.

You should be able to have your local library order a copy. There are about 10 pages to photo copy on making a churn and churn parts.

Eugene

Jeff.

E-mail me your address if you want me to photo copy the pages from my book. I will mail them to you.

Eugene
 
On the churn I use regularly the plunger is a hardwood dowel (3/4-1 inch) with softwood cross (about 2 inch wide) at the bottom. The lid is just a pass-through hole to control splashing, so it could be nearly anything. To make the cross at the bottom of the plunger, dado two pieces so that they lock perpendicular to each other, then drill a hole for a tight fit onto the dowel. If the dowel comes all the way through the hole to slightly stick out the other side, that's OK, it will mushroom out to hold on the cross. Make to sure to clean it soon after use, otherwise it gets furry real quick. I like to treat all my wood parts with mineral oil before use and before putting away.

In a couple of days I should be able to get photos

Scott
 
I thank everyone for their response. I love this. Grumpy you are right but I would say the same thing. Anymore will be useful.
Jeff
 
Back
Top