Burning Waste Oil

kinelbor

501 Club
I changed the oil in my truck today and realized since the local repair shop closed my waste oil is really pilling up. Anyone ever build a small waste oil burner? I would like to rig up something that might fit inside our wood stove so the heat wouldnt be wasted. I have been looking online a little bit, just wondered if anyone here had done something similar. 8)
 
Strange to think that when I worked in Alaska in the 50's and early 60's you wold drive on the highways at night and there would be an orange glow from time ti time. It was used crankcase and diesel dripping on to an old truck brake drum burning. This was to keep the water warm enough that it didn't freeze in the culverts under the road. There is nothing so new that it is not old.

Bill
 
In the 70's I had an old stove in my shop that I burned old oil in. It was a barrel on the bottom 18" dia. 21/2' long, with a top barrel 1' dia. 2'long made from heavy pipe. Had a small copper tube with a valve in line to adjust the flow from a tank 4' higher and half way across the shop, 10' away. The top of the lower barrel had a piece of pipe 6" long welded 1' from back for the copper tube to fit into to drop the oil into the barrel. The bottom barrel had fire brick in the bottom of it along with a foot of sand, and an old brake drum for the extra unburned oil to drop into and finish burning. Just wad up a piece of newspaper, light on fire, throw into drum, close door, open valve, adjust, let burn. cheap heat. The two barrels were fastened together at the front by a 8" long 8"diameter pipe, the heat came from the lower barrel through the vertical pipe into the upper barrel and out a flue pipe at the back. this top barrel gave out a lot heat.
 
my uncle uses one in his auto shop, he only uses oil that he has personally changed, so having different fluids in it is totally out of the question, since he only does cars... I think that he only uses the waste oil furnace to heat his whole shop, which is huge, 5 bay, 2 and 1 car deep... i don't think he's ever had any problems to speak of, except for like Rick said, bad oil, say mixed with anti freeze, hydro fluid etc, but then again, I bet he payed thru the roof for it :lol:

good luck

Johnny
 
I guess I should have reworded my original post. I just want a small rig that can burn the oil well and make a nice hot flame, just for fun, just to get rid of the oil.
 
Well I tried my really simple design today, actually worked quite well. I cut a tab out of a big cofee can and took a small computer squirrel cage fan. It moves a fair bit of air. In the bottom of the picture you can see the computer power supply rigging. It wasnt to hard to get is "started" I filled the can to the bottom of that open tab and put newspaper in it. I took the small propane torch to get the newspaper and oil burning. Once that flared up I put the fan to it and it started to swirl. It takes a little while to get the oil hot. I think I will add a second fan becuase it doesnt seem quite hot enough yet, still a bit smokey. Oh and dont worry I just shut the garage door for the picture!

DSC01406.jpg
 
When I was in the Army we had these stoves that would burn wood, coal, paper, garbage, diesel fuel, gasoline and oil. I see them on ebay for less than a $100. If you want to burn oil you need the oil burner.

Ebay listing number 140180120505
 
For many years, when doing outside projects in winter, I would feed a salamander used motor oil. It had to be outside due to the fumes, but it was very hot.
Larry
 
Back
Top