A friend of mine brought over her 5kW Briggs & Stratton Generator with a B&S engine on it so I could bring it back to life. This thing has me baffled. It had been left with fuel in it for years and had 1/4" of sludge built-up in the fuel bowl. I completely cleaned and rebuilt the carburetor. After reinstalling, it would run nicely but only on full choke. As you slowly move off full choke, it will start missing and shooting blue flames out the exhaust until about half choke where it completely dies. I've confirmed free flow at the gas line going into the carburetor.
I disassembled the carburetor again and double checked the main jet - all clean. The main jet is non-adjustable. After reassembling but before reinstalling, I used my air gun and blew air through the center of the bore with the butterfly held wide open (and fuel in the bowl). A nice mist of fuel/air blew out the other side. The only thing I hadn't removed was the idle mixture screw. It had a plastic limiting cap and when I pried it off the screw broke off. I extracted the portion of the screw stuck in the carburetor. I ordered a Chinese replacement carb and installed it (along with the new replacement .75" thick intake spacer that came with it) and new gaskets between all. The thing behaves exactly the same. I put the original carb back on with the idle mix screw from the Chinese one. No change. Adjustment of the idle mix screw seems to have no effect (even when fully closed) at both idle and full rpm. I sprayed carb cleaner on all areas of the intake while it was running and noticed no change. It's acting like it has a vacuum leak. The muffler appears to be flowing freely and the spark arrester screen is clean. The valves are properly adjusted.
I am at a loss. Any ideas?
I disassembled the carburetor again and double checked the main jet - all clean. The main jet is non-adjustable. After reassembling but before reinstalling, I used my air gun and blew air through the center of the bore with the butterfly held wide open (and fuel in the bowl). A nice mist of fuel/air blew out the other side. The only thing I hadn't removed was the idle mixture screw. It had a plastic limiting cap and when I pried it off the screw broke off. I extracted the portion of the screw stuck in the carburetor. I ordered a Chinese replacement carb and installed it (along with the new replacement .75" thick intake spacer that came with it) and new gaskets between all. The thing behaves exactly the same. I put the original carb back on with the idle mix screw from the Chinese one. No change. Adjustment of the idle mix screw seems to have no effect (even when fully closed) at both idle and full rpm. I sprayed carb cleaner on all areas of the intake while it was running and noticed no change. It's acting like it has a vacuum leak. The muffler appears to be flowing freely and the spark arrester screen is clean. The valves are properly adjusted.
I am at a loss. Any ideas?