Briggs and Stratton information request

Dennis

Administrator
Staff member
Does any member have experience with older B&S engines? I've been contacted by an individual in Germany that inherited an old B&S engine and is attempting a rebuild and needs help identifying it.

You can see pictures of it here: https://photos.app.goo.gl/eqWWLJDXWkxSYfFj6

If anyone can help him, let me know and we will figure out how to get you in contact with each other.

Thanks,
Dennis
 
Dennis I have some SN ID info that I can probably email to the person. I can communicate Via PM with the individual to establish contact. TKS Stan
 
I didn't see a Briggs ID plate on the side of the engine. Also engine shape is not familiar. How does the owner know it's a Briggs & Stratton engine?

Bore diameter and stroke will help narrow down the engine.
 
I have seen that type of engine at the Tri State gas engine tractor show that is in August every year.
I does have similarity of the REO engine on mowers years ago.
Good luck.
 
The photo of the flywheel shows a date code of Aug 1942.

Briggs & Stratton engines can be dated by several methods. These are listed below in order of their accuracy.
If the model and serial no. are known, the manufacturing date listings presented elsewhere on this website will give the month of manufacture.
A date code was used on most die cast flywheels and magneto plates. The last two digits of the year are shown in one cast in depression and a letter representing the month is shown in another. The months are lettered in order, ie. A = January, B = February, etc. Based on comparison with serial numbered engines, these dates are accurate to within several months, assuming that the parts are original to the engine. I have also found that the same type of date code is stamped into the laminations of some earlier magneto armatures.

https://www.flywheelers.com/pages/BobLearned/ident.htm
 
Thanks Everyone! I've contacted Mario and he is also following the topic online. If he has further questions, he may allow me to give you his email address.

Thanks!
 
Back
Top