I don't know if this is the right place to post this but it is off topic. lol
We are having an issue with our outboard boat motor. It sounds as if it is starving for fuel but everything that we've looked at looks like it's ok and not the problem.
Here's what we've done so far. (And yes, I was playing the part of a mechanic too!) LOL
Cleaned carb...jets (and everything that had a small hole in it) were full of gunk...got everything cleaned out and put back together.
Started the motor and it would die. Ordered a carburetor repair kit and took the carb back off and re-cleaned everything, just in case we missed something, replaced all new parts that came with kit, and put it back together.
Started the motor and it continued to run, although, sluggishly. The motor does sound as if it's starving for fuel but there is no place on the carb to adjust the fuel/air flow mixture. We've gone over everything several times and can't figure this one out. The next thing Hubby plans to do is pull the plugs and check them out. Other than that we're stumped.
Could it be an electrical problem or should we stay focused on the fuel end of it?
The motor is a 2003 Yamaha F25ESHB.
Thanks in advance
We are having an issue with our outboard boat motor. It sounds as if it is starving for fuel but everything that we've looked at looks like it's ok and not the problem.
Here's what we've done so far. (And yes, I was playing the part of a mechanic too!) LOL
Cleaned carb...jets (and everything that had a small hole in it) were full of gunk...got everything cleaned out and put back together.
Started the motor and it would die. Ordered a carburetor repair kit and took the carb back off and re-cleaned everything, just in case we missed something, replaced all new parts that came with kit, and put it back together.
Started the motor and it continued to run, although, sluggishly. The motor does sound as if it's starving for fuel but there is no place on the carb to adjust the fuel/air flow mixture. We've gone over everything several times and can't figure this one out. The next thing Hubby plans to do is pull the plugs and check them out. Other than that we're stumped.
Could it be an electrical problem or should we stay focused on the fuel end of it?
The motor is a 2003 Yamaha F25ESHB.
Thanks in advance