Boat Motor Carb Issue? Help

Rianna

Well-known member
I don't know if this is the right place to post this but it is off topic. lol
We are having an issue with our outboard boat motor. It sounds as if it is starving for fuel but everything that we've looked at looks like it's ok and not the problem.
Here's what we've done so far. (And yes, I was playing the part of a mechanic too!) LOL
Cleaned carb...jets (and everything that had a small hole in it) were full of gunk...got everything cleaned out and put back together.
Started the motor and it would die. Ordered a carburetor repair kit and took the carb back off and re-cleaned everything, just in case we missed something, replaced all new parts that came with kit, and put it back together.
Started the motor and it continued to run, although, sluggishly. The motor does sound as if it's starving for fuel but there is no place on the carb to adjust the fuel/air flow mixture. We've gone over everything several times and can't figure this one out. The next thing Hubby plans to do is pull the plugs and check them out. Other than that we're stumped.
Could it be an electrical problem or should we stay focused on the fuel end of it?

The motor is a 2003 Yamaha F25ESHB.

Thanks in advance:)
 
Rianna - check the spark plugs and also the air flow to the carburetor. It could also be a weak spark issue.
 
He's going to check the spark plugs this afternoon, unless he has to work late. He may know this but I don't so...how do you check the air flow to the carb?
I've seen him do this: Hold his hand up to the air vent (?) and it would help him start the motor. There's no choke on it and this has always helped when trying to start it. After rebuilding the carb, he didn't have to do this so hopefully he won't have to do it again.
Thanks for the info Bigdog!!
 
I'm assuming that it is a 2 cycle? I would definitely replace the plugs. Yamaha recommends NGK's. Make sure you gap them according to the owner's manual. You should also replace the fuel filter. And I would drain the tank (if you can) and use fresh fuel. I always put Sta-Bil in mine every time.
 
I don't know if it's a 2 cycle or what. I think I remember him saying it's a 4 stroke, if that helps. I really need to get all of this information and keep it handy, don't I?
Fuel filter was replaced before we started on the carb. I suggested the "KISS" method...start with the simple and go from there:) See, I've been paying attention to all of the advice on here!! :{_}:

I am going to add more info here so that you can see when all of this became a problem for us.

The motor was running good at the beginning of the season. First thing that went wrong was the spring in the starter bendix broke. Got that replaced. Went to the river and started the motor (had to take the cover off and put his hand on the air vent to get it going). Motor started and sounded sluggish. Sat there and let it warm up and headed up river. He mentioned that it just didn't sound right and that it needed to "kick in". I didn't understand what he meant because I wasn't paying attention to the sound of the motor. (I was ready to fish!! lol) We slowly made it up the river and all of a sudden, it felt like a power surge and it "kicked in". He turned the throttle almost all the way up and even though it was going faster, he said that it still didn't sound right.
When we got ready to leave and started the motor, it did the same thing.
Is there any chance that the starter bendix messed up the timing in any way?

I'll update on the spark plugs when he has a chance to check them out.

Thanks for the info!!
 
My recommendations are the same, regardless whether it is 2 cycle or 4 cycle. I can't imagine that repairing the starter is related to your current problem.
 
Don McCombs":x4djkpgs said:
My recommendations are the same, regardless whether it is 2 cycle or 4 cycle. I can't imagine that repairing the starter is related to your current problem.

Thanks! I didn't think it would but didn't want to leave that out of the equation.
 
Quote: "When we got ready to leave and started the motor, it did the same thing.
Is there any chance that the starter Bendix messed up the timing in any way? "

Don't think the Bendix hurt anything.

2 cycle motor you mix oil with gas.

New plugs will probably help.

You do have fresh gas in it right?

When is the fish fry? :D :D :D
 
Web search says 4 stroke aluminum engine.

Symptoms described could ignition and or fuel related. Might even be engine mechanical - since I am not familiar with that engine.

Suggest visiting the reference section of your local library for a Clymer (brand name) book on the engine.
 
Mike in Louisiana":17d80vkz said:
Quote: "When we got ready to leave and started the motor, it did the same thing.
Is there any chance that the starter Bendix messed up the timing in any way? "

Don't think the Bendix hurt anything.

2 cycle motor you mix oil with gas.

New plugs will probably help.

You do have fresh gas in it right?

When is the fish fry? :D :D :D

Ruled out bendix messing things up...

2 cycle motor/mix oil with gas...I should have known that. :oops:

Gonna check the plugs...

Fresh gas...hmmm...it's about 3 weeks old now, if that. He does mix in some type of stuff but I'm not sure what it is...a stablizer or preventative? Will ask for future reference!

Fish fry?? lol We only have the 15 pound yellow cat in the freezer and a few small ones...which means we've got to get this fixed so I can catch another 15 pounder...then we can have a fish fry!!! It's time for a good fish fry around here!!
 
Eugene":3ka9o9xu said:
Web search says 4 stroke aluminum engine.

Symptoms described could ignition and or fuel related. Might even be engine mechanical - since I am not familiar with that engine.

Suggest visiting the reference section of your local library for a Clymer (brand name) book on the engine.

Thanks! I'll check into it after we rule out the spark plugs.
 
UPDATE: Hubby's eatin' crow for supper!!! :lol: I suggested he check the spark plugs yesterday and he said that they were still good. Well...when he came in from work, he checked the spark plugs and dang if one of 'em didn't fire at all. Hopefully this will solve the issue and we can finally go fishing!!

Thank you all so much for the information and suggestions. You have no idea how much we both appreciate you all.

(Just want to make sure you know the crow supper is a joke...I wouldn't really make him eat it...would I??) :twisted: :lol:
 
Rianna":15pgsn90 said:
UPDATE: Hubby's eatin' crow for supper!!! :lol: I suggested he check the spark plugs yesterday and he said that they were still good. Well...when he came in from work, he checked the spark plugs and dang if one of 'em didn't fire at all. Hopefully this will solve the issue and we can finally go fishing!!

Thank you all so much for the information and suggestions. You have no idea how much we both appreciate you all.

(Just want to make sure you know the crow supper is a joke...I wouldn't really make him eat it...would I??) :twisted: :lol:

I'm thinkin'..............yes! :lol:
 
Bigdog":mdqqui25 said:
Rianna":mdqqui25 said:
UPDATE: Hubby's eatin' crow for supper!!! :lol: I suggested he check the spark plugs yesterday and he said that they were still good. Well...when he came in from work, he checked the spark plugs and dang if one of 'em didn't fire at all. Hopefully this will solve the issue and we can finally go fishing!!

Thank you all so much for the information and suggestions. You have no idea how much we both appreciate you all.

(Just want to make sure you know the crow supper is a joke...I wouldn't really make him eat it...would I??) :twisted: :lol:

I'm thinkin'..............yes! :lol:

:bellylaugh:
 
Back
Top