Belly mower drive pulley

J

JB76

New member
New to the farmall family and just acquired a farmall cub with I think a Danco belly mower and it seems to be missing parts or something. The drive pulley isn’t engaging the blades from what I could find online possibly missing parts of the clutch assembly missing. All assistance would be greatly appreciated.
IMG_0784.jpeg
 
You have a ratcheting clutch on the mower, which is a good thing. Each of the four holes in the large pulley should have a spring and short pin. When turned upside down on the center spindle, the pins will catch on the end of the "ramps" and spin the blade. There should be a "domed" washer like piece that sits on top of the pulley with a nut to hold it to the spindle.
 
Bob McCarty said:
You have a ratcheting clutch on the mower, which is a good thing. Each of the four holes in the large pulley should have a spring and short pin. When turned upside down on the center spindle, the pins will catch on the end of the "ramps" and spin the blade. There should be a "domed" washer like piece that sits on top of the pulley with a nut to hold it to the spindle.
Click to expand...

Bob McCarty said:
You have a ratcheting clutch on the mower, which is a good thing. Each of the four holes in the large pulley should have a spring and short pin. When turned upside down on the center spindle, the pins will catch on the end of the "ramps" and spin the blade. There should be a "domed" washer like piece that sits on top of the pulley with a nut to hold it to the spindle.
Click to expand...
Thanks. Any suggestions where I could purchase replacement parts?
 
Messicks.com is a good place to start. You're probably going to have to have a make and model number of the mower to get much info. JMHO Stan
 
Suggest you place a wanted add in the VINE, Classified forum for the parts you need. Someone may have a spindle assembly that they would sell. JMHO Stan
 
You must log in or register to reply here.
Back
Top