Bell Telephone Tool

redfin

501 Club
I know we have a few folks here that retired from the Bell Telephone Company. I came across this old hammer that is marked Bell Systems . I know it is not a valuable piece but I am interested to know what it was used for specifically and what time frame it was used. I suppose pole staples etc , but I would like to hear from you guys. Thanks in advance. :D

normal__%28KGrHqN%2C%21h8E6GPgEe%21sBOqhEQT%2Byg~~60_3.jpg
 
This is in Bigdog's signature line:

"If you can't fix it with a hammer, you've got an electrical problem."
 
Stepping hammer. Used to drive steps in the poles that you sometimes see close to the top of poles. Been around and used as long as their have been pole steps. Not used near as much as they used to be due to buried cable and bucket trucks, but still have their uses, including dropping on a dog that is trying to bite you when you want to come down from a pole. I was never Bell, but it is still used the same, no matter what TELCO you work for.
 
Oh yeah they are good for dogs, especially in a cellar in Harlem. Been there did that. It is a 2 pound drilling hammer used with a Star Drill to punch holes in Brick, mortar or cement. You then insert a, used to be lead anchor. Now plastic, then you inserted a drive ring, screw ring or screws or lag bolts to hold terminals or cable clamps. You also could use a drive nail in the hole for many of the same hold up jobs
The ones John talked about for Bell Heads were 5 pound , larger head and longer handle. The back didn't come to an almost point but tapered top to bottom on the back of the head. There is a hole in that part used to screw pole steps. Made many a dollar swinging those guys. The star drill was a rubber covered steel handle into which you inserted bits of what ever size you needed. The bits had a tapered round top and you forced them out of the handle with a flat steel tapered wedge.
The sissies these days use a hammer drill.

Edit to add
HILTI nails and studs do same of the same hold up jobs today too.
 
Beaconlight is correct, my memory is not as good as it ought to be. Plus, I never worked outside, just the offices and data circuits. but as I said, no matter which one, they were good at teaching K9s obedience, more than one learned to roll over and play dead when they got too territorial.
 
Used now by the cable company independent contractors to drive lag screws into poles to install a cover/shield on the cable transitioning from buried to aerial. In the process, the slots on the cover are broken and the cover falls off a few days later when a gust of wind hits it. They install the covers after they discard their trash in the hay fields. Want a Scientific Atlanta box that is used as a take-off point to serve residential customers? Want a 12 foot piece of coax cable about 1" diameter? I collected them before they went through the baler.
 
Boss that is a problem today. We were taught, you bring it in you bring it out. Just like hikers are supposed to do. While walking the dog i often pick up old pieces of cross connection wire under terminals on poles.
 
Back
Top