batttery terminal remover

I found this in a local sporting goods/pawn shop when I went in looking for ammo. It appears to be the right size and shape for a battery terminal remover, but who ever heard of a slide hammer puller for battery terminals, I would think that would be a good way to damage a battery. When looking at it I noticed the knob on the end has an allen head socket in it, which would allow it to be used as a normal battery terminal puller. Anyone have any other ideas?
0414161616.jpg
0414161617.jpg
 
John,

That is a pretty sophisticated plumbing tool. A faucet handle remover that is missing the end (without it, it is useless for its intended purpose) right near the threads. That end was inserted where the screw was located then the jaws were tightened on the lever, a couple or more taps with the slide hammer and the lever came off. The one I used when Jo and I managed a 52 unit apartment complex was much less sophisticated. :D

Bill
 
I knew someone on here would have the answer, and that is a lot more reasonable than my idea. Was the missing piece an adapter that held a screw the size of the one in the faucet?
 
John,

Just a part of the rod that was machined smaller than the screw. It sole purpose was to locate the shaft so that the shaft would not interfere with the lever you were removing. Stubborn levers could break that small pin off. I'm thinking that if you examine the end of it, you will find evidence that it was broken off.

Your post brought back many pleasant memories of my time at Texas A&M. :thumbsup: :thumbsup:

Bill
 
Back
Top