Merlin,
You got me with the three prong female connector. It’s been awhile since I worked on an early Chevy throttle body. The only thing I could think it is; the primary coil connector that connects to the ignition module at the distributor. One terminal is 12 volts, the two center terminals connects to the ignition module and one terminal goes to the instrument panel tachometer. If that’s not connected you have found your problem
Ok… with the diagram attached
http://img.photobucket.com/albums/v688/ ... oject1.jpg [/url] (I hope it’s plain enough to see) this is what I want you to do, to diagnosis your no start. (Ignition on) First check the ignition 15 amp. fuse I have circled.(Next)Remove the connector off the fuel injectors and use your test light and see if you have 12 volts at the red wires. Next check the (Computer) ECM/Ignition fuse and sees if it is open. If it is not remove the ECM (Computer) connector and see if you have 12 volts at terminal A6 circuit 435 grey wire.
If all that checks out next, disconnect the distributor 4-way connector, Ignition on, momentarily touch harness connector terminal ckt. 430 with a test light to 12 volts. See if the injectors pause. The injectors should pause every time you touch the terminal. If the injectors pause you have a faulty ignition module or a bad connection from the ECM to the ignition module.
If everything checks out to this part you need a special tool called an injector test light. Really this is the first test you should do, but if you don’t have the injector test light I was going around it thinking you will find the problem before you need it.
How the systems works is; the ECM (pulse) grounds circuit 467 and 468 (terminals D16 and 14) to complete the path of current (12 volts circuit 448) to make the injector(s) work. The ground on the ECM can only take so much current (10 mega ohms of resistance). If you use your test light to check and see if the ground (circuit 467 and 468) of the ECM is pulsing you might destroy the ECM. The ECM’s are protected by quad drivers and the GM ECM is very resistant to punishment but you know how Murphy’s Law goes.
If the attachment is not clear enough I can send it directly.
I hope this helps. Don’t worry about bothering me, that’s what friends are for.
Jack