Automobile computers

Bus Driver

501 Club
I may have my first-ever failure of the ECM - engine control module- on one of my vehicles. It is a 1988 import known for reliability and it certainly has lived up to the reputation. In this case, it quit on the road and I had it towed to a garage. I usually do the repairs at home, but did not know when I could get to it this time. Shop has no way to test the ECM, just substitute another.
With used ones from the wrecking yard, I am sure that the yard has no testing method, they just sell it and most of them prove to be usable. Based on your experience, if any, is it highly likely that if one bought two ECMs from the wrecking yard, at least one of them would be usable? My thinking is that the answer is yes.

I did once have a car (different brand) on which the ABS and the climate control modules each failed. That car had lots of failures and I do not shop that manufacturer's brands any more.
 
I was able to buy a refurbished one, for an '86 Bronco, with guarantee for about $100, but some cost much more. I'd check online to see what the cost is, that price included a core exchange. At $100, I will go with reworked as opposed to junkyard...but like I said, many are in the $300-$400 range also....
 
On our 92 Plymouth Acclaim we had the map sensor go. Them puppies are really expensive. Our local scrap yard always pulls the map sensors/ECM's on all cars so they are indoors. We bought one and plugged it in. Worked perfect and saved us a lot of money. Same deal on our 87 Plymouth Grand Voyager. Map sensor went. Bought a used one from the scrap yard and it performed flawlessly.

Is it worth the shot? Probably, but then only you really can decide.
 
Jumping to conclusions, the limited number of responses leads me to believe, as I already did, that the ECM rarely fails. And if it rarely fails, the chances of a used one being good are enhanced. For 1988, I wonder how much diagnostic ability the dealer still has. Some of the workers in this garage may be younger than the car.
 
BD:

I think the likelihood of that is akin to the likelihood of most of these youngun's on parts counters to even know what a Cub is :lol:
 
My experience with The ECM is pretty limited, but my understanding is that on the older vehicles they could be pretty much just swapped out. On the later models though there was quite a bit of programming that had to be done, as it had to match the rest of the modules installed in the vehicle.
 
Back
Top