Are all FM radios the same?

john2189

501 Club
My radio has a one wire antennae and with the flouresant lights on it has a lot of static turn lights off it’s clear as a bell. I was going to buy a radio that can take an external Antennae but afraid it won’t be any better.
Anyone have a cure for the static?

John
 
I have the same problem with my fluorescent lights. I have had the problem from the time they were new.
 
This is typically an issue with the radio's ground. To test the theory, run a separate wire from the vehicle ground point to the chassis of the radio and see if the issue clears up. (use something like a jumper cable for the test). If the issue goes away during the test, use a 14 or 12 awg wire for the ground.
 
outdoors4evr":4ae6v0qc said:
This is typically an issue with the radio's ground. To test the theory, run a separate wire from the vehicle ground point to the chassis of the radio and see if the issue clears up. (use something like a jumper cable for the test). If the issue goes away during the test, use a 14 or 12 awg wire for the ground.

I'm having the issue as well in my new barn. Can't listen to the baseball game with the lights on.

Don't know where I'd tie a ground wire into the radio. It's a digital AM/FM/CD player. Have another on that is analog radio; gets interference too.

Where would I connect a ground wire to?
 
My radio has two ports on the back to attach the little antenna that came with it. I have stretched the antenna as far from the radio as I could. I have also hooked up a piece of 12awg electric wire and connected it to the tallest metal shelf in the shop and still have the problem.

I have several radios I used in the house and brought them to the barn and I have the same issue.
 
Barnyard":27mqdst1 said:
I have the same problem with my fluorescent lights. I have had the problem from the time they were new.
I suspect "cheap" fluorescent lights don't have RF shielding like may be built into better ones. Likewise, the plastic cases typical of many radios don't provide shielding like a metal case would.
Stanton":27mqdst1 said:
Don't know where I'd tie a ground wire into the radio. It's a digital AM/FM/CD player. Have another on that is analog radio; gets interference too.

Where would I connect a ground wire to?
For non-vehicle radios, there is often a ground lug somewhere near the antenna connection. If thre is none, look for a screw that holds the case together. Just make sure it is one that screws into metal, not just the plastic case. Connect the other end of the ground wire to the building's electrical ground. A screw that holds an outlet plate will work.
 
Jim Becker":xksc7p33 said:
I suspect "cheap" fluorescent lights don't have RF shielding like may be built into better ones. Likewise, the plastic cases typical of many radios don't provide shielding like a metal case would.
Well at $89.00 per fixture and $8.00 per bulb I will rule out the lights and concentrate on the plastic radio case.
 
Mine are used t8 from a showroom that we remodeled at work. I dont think they would be cheap ones. I am going to drill a hole in the wall and shove the single wire antennae outside to see if that helps.

John
 
AM (amplitude modulation) is especially susceptible to the ballast frequency. Heck you know all this stuff and I park the radio at a certain angle where it works. Before I leave this, some thing else. Your radio has an active AM antennae. It is there in the circuitry. Just for S's and Gs , wrap some aluminum foil around the radio. Opening for speaker.
 
LOL
Took my radio apart last night to find a good connection for a ground. Instead, couldn't get the thing back together. So, just threw the whole thing away.

My "midas" touch isn't so golden.
 
Stanton":14oemilj said:
LOL
Took my radio apart last night to find a good connection for a ground. Instead, couldn't get the thing back together. So, just threw the whole thing away.

My "midas" touch isn't so golden.
Your shop is FINALLY peaceful :lol:
 
Shane Nelson":2lm1j3sa said:
Stanton":2lm1j3sa said:
LOL
Took my radio apart last night to find a good connection for a ground. Instead, couldn't get the thing back together. So, just threw the whole thing away.

My "midas" touch isn't so golden.
Your shop is FINALLY peaceful :lol:

No, but I get your sentiment. I have a backup analog radio. I really liked that digital one 'cause I could lock into weak signals with the exact station number.
 
Ok I straightened out a wire coat hanger,wrapped the end of the one wire antennae and raised it in the air beside one of the light fixture and radio clear as a bell so I hung it to the light fixture. So far all is good.
John
 
Back
Top