M Mamachala Active member Jan 30, 2004 #1 Apparently you have to cut the welds on the sleeve to replace the bearings. Anyone have any experience with this procedure? Thanks Jack
Apparently you have to cut the welds on the sleeve to replace the bearings. Anyone have any experience with this procedure? Thanks Jack
A artc 501 Club Jan 30, 2004 #2 jack, i'm not familiar with that mower, but if you take a look on Rudi's manual site, you'll probably find the info. http://www.cleancomputes.com/Cub/index.html Welcome to the forum :!:
jack, i'm not familiar with that mower, but if you take a look on Rudi's manual site, you'll probably find the info. http://www.cleancomputes.com/Cub/index.html Welcome to the forum :!:
M Mamachala Active member Jan 30, 2004 #3 Yes, the Woods manual says to just buy a new spindle assy., $220.00. Thought I could save alot of money by just replacing the bearings and seals, and wondered if pthers have had any luck doing this. Thanks Jack
Yes, the Woods manual says to just buy a new spindle assy., $220.00. Thought I could save alot of money by just replacing the bearings and seals, and wondered if pthers have had any luck doing this. Thanks Jack
