Allis Chalmers G Sparking When I Unhook Battery

:help:

I have a new 6 volt battery and new battery cables. I'm getting a good ground because when i go to hook up the ground cable I get a substantial spark from the battery post. I have ensured that no battery cable is touching anything. The reason for all of this discovery is because the tractor will not start. I am getting no voltage to the starter....pull the rod and acts like a dead battery. Where can my problem be?
 
Ok.....figured out the problems (kind of).

Bench tested starter and it worked, so I decided to test the "New looking" 6 volt battery on the tractor even though I had charged it and was getting spark with it. It tested at 2.4 volts. DEAD. Reinstalled starter and I went and got a 12 volt truck battery and went to hook it up on the tractor keeping the positive ground system. Got a large spark this time so I decided to unhook the wire on the generator closest to outside (on the very top). When I unhooked that wire the sparking at the battery stopped. Sorry for not knowing which wire I unhooked, as it was dark outside and I couldn't make much of anything.

Anyways....put some gas in her, turned on the fuel valve, sanded the points a little, and she fired to life!! Ran good with no smoke for a couple minutes then died. Carburetor was dripping gas, and I tried to restart with some ether to no avail. I got a couple of pops and then it wouldn't do anything after that. I presume that the plugs got wet since the points were still firing. Looks like she'll need a tune-up and carburetor rebuild at the least.

What could be the problem with the electrical system? The Voltage Regulator? (The reason I didn't mess with the VR is becuase the hood is on the tractor and it's hard to get to. )
 
Back
Top