2000 Buick Century Fuel question

Clem

501 Club
I have a problem with my fuel gauge on my wife's Buick. The gas needle will read 1/8 full or even empty until I press the gas peddle down. As my speed increases the gas gauge reads fuller and fuller. As I lift off the gas, guge will read lower and lower to almost empty. In nuetral it reads low fuel, and as rpms are increased it remains low.

thanks,

Clem
 
Dan,

Sounds like the older type with a float that will move up and down as the gas sloshes in the tank...........

Is this a new problem?
 
Keep it at about half throttle all the time and you'll never run out of gas!

Seriously, is the car equipped with gauges and a tachometer? If so it might be a short in the printed circuit on the back of the instrument cluster.

Does the fuel gauge rise when you accelerate in park while sitting still or only while moving?
 
I filled the tank up today and drove it up north and back and here is what I observed.

full tank of gas, no problems
1/2 tank, just fine.
1/8 tank, needle got jumpy
On E, needle got way jumpy.

This is a new problem. There is no tach on the instrument cluster. The problem only occurs on a low tank and only when the tank is moving.

Thank you.
 
Clem,

I started this post and had to leave for awhile and then I read your last post. Your last post states a completely different issue like you said. The last issue you stated is a fuel sender circuit board inside the fuel tank. This is a normal issue with a GM car. What is happening the fuel sender circuit board gets a residue on it from fuel additives and causes fuel gage issues. I don’t think there is anyway you can repair it with out replacing the fuel sender circuit board.

This is my other diagnosis on your first post.

The fuel gage circuit is a little complicated in that car. Below is a description of the operation of the circuit. I feel you have an intermittent connection or open under the hood most likely where the body wiring harness rubs against the transmission at point 1 in my illustration. Follow the body wiring harness (pull it away from the transmission) and see if you have any chaff marks. Have someone look at fuel gage and see if it moves around while you are moving the harness. You must have the key on and engine not running. While you’re in that area check the grounds at point 2 in my illustration. Another thing that just came to my mind is the under hood fuse box. It was a big issue on the GM “W” body’s a couple of years ago on problems like you’re having. Move the wiring under the fuse box around and see if the fuel gage varies.

If nothing is visible I suggest taking the car to a professional. I can help further, but it incorporates diagnosing modules and connections.

If you want to diagnose your car further just drop me a line, but I’ll be out of town until next Friday evening.

After the car is repaired, please let me know what you find.
http://docs.google.com/Doc?id=dcpqrttm_236f84cqqd9

Fuel Gauge
The Powertrain Control Module (PCM) broadcasts the fuel level data via the class 2 serial data line (High-speed data between modules). The instrument cluster compares the fuel data using a 16-point look-up table in order to determine the needle deflection. A smooth filter is used in order to secure a continuous response. The instrument cluster may determine if a low fuel condition is present. In the event of a low fuel condition, the following conditions may occur:
• The instrument cluster shall activate the LOW FUEL indicator.
• Send a chime message to the Body Control Module (BCM).
The instrument cluster may drive the fuel gauge to E (empty) under the following conditions:
• The fuel level data is lost.
• The PCM is in a state of health fault.
 
Back
Top