1964 Ford Truck Carburetor Help

Rianna

Well-known member
*note* I know nothing about this stuff!!!

I need help locating a 1 barrel carburetor (prefer the Holley brand) for a 1964 ford pickup truck. It's a 6 cylinder with a 223 engine. The carb also needs to have a bolt (or something) for the OIL BREATHER to attach to. I hope this is the correct information!! I'll try to get more info from Daddy if you need more. It's a F 100 series...there is a Y shape wire that clips on the top of the carb...it has ears on the side of the carb that it attaches to.

The carb that's on his truck now has a screw on it that has become loose. It won't tighten up and he's afraid that it will pop out while he's driving and cause an accident. He's bought several rebuilt carbs over the years and so far, none has been the correct one.

fyi...Daddy bought this truck one month before I was born. :) He has over 300,000 miles on it and has never had to do any major fixes on it other than the carburetor. It still has it's original paintwork, although faded in some spots, few rust spots, and if I'm not mistaken, the same rims that came on the truck. He wants to get the carb fixed, find the trim that goes around the doors and windows, and possibly install a heater of some kind in there.

If you know of any direct links to the carb, please post them here.

Thank you in advance.


*EDITED information in BOLD*
 
Rianna, if the screw keeps coming loose, perhaps it could be heli-coiled. That would be a lot less costly than a carb. Check with some of your local garages to see if they offer this service.
 
Thanks Barnyard! I'll relay that to Daddy and see if he wants to go that route. I think he's said before that this carb is not the correct one that should be on there but if the heli-coil deal will work, he may decide to try it.
Thanks again!
 
Rianna,

Is there any way that you could post a picture of the carb. I know the carb that you are working on but I can not picture the bolt that you are talking about.

Mark
 
flyawa":2j5a5lxd said:
If you can get the numbers of the carb that he needs I have several places that might have one.

That's the problem, we don't know the numbers since the carb that's in there now is not the right one. Where should I begin to look for the right numbers?

cubguy's dad...I will try to get the pictures today, but as I've stated before, this carb is not the correct carb for his truck. This one came from O'Reilly's and it's never worked right. My nephew now works at O'Reilly's and he hasn't been able to find the right one yet.


Thanks for the responses...hang in there with me as I try to get more information for you.
 
Rianna,
Best i can remember we have a member who is/was a parts man for Ford. I think he was layed off. Maybe some one else can tell you who it was.
 
Rianna,

http://www.a1aautoparts.com/ They say that they have one for a 1964 Ford F100 with a six cylinder. You will need to contact them.

Those Holley Carbs that came OE on that 223 engine are hard to find. I know what you are talking about, unfortunatly I am old enough to remember working on them.

This may be the one you are looking for and they are located in Florida,not to far away. It will probably need a rebuild before using it.

I would guess that you probably have a Motorcraft on it now and that was a typical replacement carb for the Holley. This carb may be repairable and work until you can locate a original.

Good Luck

Mark
 
Back
Top