Picked up a John Deere BO at auction

Installed the first reduction gear bearing and the clutch pulley bearing. The clutch bearing race thats pressed onto the crank fought me some. Tried heat and peening to expand it with no luck so I carefully cut a groove with a cutoff wheel and hit it with a cold chisel to expand it. That worked and I am ready to drive the good used on. I found a piece of pipe the right diameter that I will face off in the lathe for the driver to slip over the end of the crank.
 

Attachments

  • 100_9440-m.JPG
    100_9440-m.JPG
    189.2 KB · Views: 1
  • 100_9442-m.JPG
    100_9442-m.JPG
    123.1 KB · Views: 1
  • 100_9443-m.JPG
    100_9443-m.JPG
    138.1 KB · Views: 1
  • 100_9444-m.JPG
    100_9444-m.JPG
    116.4 KB · Views: 1
  • 100_9445-m.JPG
    100_9445-m.JPG
    117 KB · Views: 1
  • 100_9446-m.JPG
    100_9446-m.JPG
    114.2 KB · Views: 1
  • 100_9447-m.JPG
    100_9447-m.JPG
    127.5 KB · Views: 1
  • 100_9450-m.JPG
    100_9450-m.JPG
    126.3 KB · Views: 1
Back
Top