Question about the TC lever sectors

havoc1482

501 Club
Here is a video of my question figured a visuals are worth a 1000 words.


Long story short, is the top sector sections (where the lever stops slide on) supposed to be flared wider than the base they are mounted to? The coupler nuts/spacers at the top are wide enough that they would flex the top out. I can't see why it would ultimately matter, but academically speaking, I am curious.

Thanks fellas
 
There were 2 versions of many of those parts, 3 versions of some. I don't know the answer to your question and don't have one here to look at. But my hunch is that you have a mix-and-match of different versions. the quadrants should be on the outer sides of the arms that support them. Mounting them inside would make the situation worse. From the video, it looks like you are putting them on the outside.
 
Appreciate it, Jim. I just realized the video is really quiet, I apologize for that, but the closed-captions seem accurate. Anyway, I'm looking at my parts catalog right now. It lists the Hex shaped coupler (what I have) as early production serials (250001-277988) so that seems correct. (My SN is 259383).

I just realized the TC Temp Gauge I have (not shown in the video) is also the same width as the hex spacer. Maybe it is supposed to be like that, interesting. 🤔
 
Appreciate it, Jim. I just realized the video is really quiet, I apologize for that, but the closed-captions seem accurate. Anyway, I'm looking at my parts catalog right now. It lists the Hex shaped coupler (what I have) as early production serials (250001-277988) so that seems correct. (My SN is 259383).

I just realized the TC Temp Gauge I have (not shown in the video) is also the same width as the hex spacer. Maybe it is supposed to be like that, interesting. 🤔
Where did you get the fiber discs? I'm going to be looking into my tc quadrant over the winter to get it working correctly.
 
Where did you get the fiber discs? I'm going to be looking into my tc quadrant over the winter to get it working correctly.
Steiner Tractor. Though I realize in hindsight I probably could have come up with a cheaper solution, especially considering the spacers I needed are a different size for earlier production Super A. (1/16" vs 5/32" for early and late respectively). They appear to simply be a cork washer.

I think there are posts on here about people making their own for their Cubs, I'm sure extrapolating that info for your tractor would work.
 
Back
Top