D Detz#2 Member Saturday at 9:35 AM #1 I received a governor and housing from JP Tractor Salvage and will install them soon. Do I just pry out the old engine governor throttle oil seal?
I received a governor and housing from JP Tractor Salvage and will install them soon. Do I just pry out the old engine governor throttle oil seal?
D Detz#2 Member Saturday at 1:28 PM #2 Detz#2 said: I received a governor and housing from JP Tractor Salvage and will install them soon. Do I just pry out the old engine governor throttle oil seal? Click to expand... It’s out I had seen a statement somewhere to drive it out from the inside with a punch but I didn’t know if that was even possible.
Detz#2 said: I received a governor and housing from JP Tractor Salvage and will install them soon. Do I just pry out the old engine governor throttle oil seal? Click to expand... It’s out I had seen a statement somewhere to drive it out from the inside with a punch but I didn’t know if that was even possible.
G Glen 501 Club Saturday at 7:50 PM #3 Detz#2 said: I had seen a statement somewhere to drive it out from the inside with a punch but I didn’t know if that was even possible. Click to expand... Hi, Yes, that is probably what I wrote. If it will pry out, that is ok too. Below is your other post about the seal, I wrote installation instructions, at the last post on the page, don't hammer directly on a new oil seal, it can bend it. D Thread 'Replacing rockshaft gasket' Oct 26, 2026 attempting to put in a new rockshaft gasket but the shaft only pulls out about .5 inch. I don’t see a woodruff key Last edited: Saturday at 7:58 PM
Detz#2 said: I had seen a statement somewhere to drive it out from the inside with a punch but I didn’t know if that was even possible. Click to expand... Hi, Yes, that is probably what I wrote. If it will pry out, that is ok too. Below is your other post about the seal, I wrote installation instructions, at the last post on the page, don't hammer directly on a new oil seal, it can bend it. D Thread 'Replacing rockshaft gasket' Oct 26, 2026 attempting to put in a new rockshaft gasket but the shaft only pulls out about .5 inch. I don’t see a woodruff key
